Forum Replies Created
-
Posts
-
Re: hnc175-80
connections part number 5045174299824 or hoover part number 40004946 worked a treat and alot dam cheaper
phil
Re: Candy DW CDI1012/b Error codes.
leiter counter bugged try soldering the leads directly to it iff not try a new one
Re: Bosch SMS40A08GB/01 D/W A few questions.
just change the flow meter all will be good . just follow the inlet valve till you find it , it will have 2 thin blue wires on it ..
For future reference, how do you get to the motor, heater, etc on this new type of sealed base bosch? Well thats goner be a learning curve ..
Re: New Whirlpool dishwasher wash pump reliability
Askoll pumps are crap , i will not fit them had to many come back to haunt me
Re: HOTPOINT SEMI INT DW LFS 114
could be pcb , but would look at the ntc attached to the lower pcb at the front , lower panel , it has a short lead and can come detached
Re: FZA34P Hotpoint Freezer
draws out back wall removed it will be frozen up , take a hair dryer to it , be carefull of the sensors though .
done a few changed just about every thing on them but 2 years
later frozen up againhth phil
Re: Hoover VHD9143ZD
motor controle pcb at the bottom left looking from the back iff its got one , other than i am puzzeld why there is no fault code coming up , did you let it time out ? or could be low insulation heater can cause havic with these ,,
Re: Hoover GO292-80 Washing machine
I am doing ok bobhope busy as a bee in summer . the offcial fix for the tumble dryers is place a bowl of hot water in the drum for ten minutes , the try again , surpose it mite work for the washers to lol .
i persnaly use a hair dryer .Re: Hoover GO292-80 Washing machine
more likly a sticky button ( stuck in ) never come across washing machines not working in cold weather only the hoover candy tumble dryers not working , but hey one never noes all .
Re: Servis fridge freezer
motor not running , do you mean fan motor in freezer or compressor . ? iff fan it will the the reed switch on pcb ,
iff its comp it will be a cap on pcb , carnt remeber wich one atm will get back to you ,,,Re: Whirlpool for Ikea
change the dispenser solenoid , or disconnect it see how that goes , iff its the rectangular brown one that will be the problem .
hth
phil
Re: HOOVER VHC680F START CAP – HOW THE BLOODY HELL ……
dam piece of shxt they are , ok top off front off unscew the pcb from the chassey gives you more to work room to work with
remove the lower bottom metal plate at the front, fan chamber
on left will unclip and remove lol , it takes some twisting and turnining untill it comes out . now yer can get yer arm in .
Tricky it is yer can feel about , 13 mil spanner cut down in half will undo the nut , ALL ONE HANDED I AM AFRAID it can be done . Hardest part is putting the wires back on the cap .
or a full strip down drum out .
philRe: Ignis ADL349/A 854534915820 Strange fault
repmans probly rite , put a fly lead to it see iff it runs iff it rattles its bollexed if its the one with a pcb board attached to the coil , were your meter will not get a circuit , run it , then try it again , 9 times out 10 it works .
ok if it works split the pump see if there is water in the magnet roter , dry out and put a drop of oil in it , and bobs yer auntydone a few like that not seen them again
yes i like to tinker with stuff lol
