Forum Replies Created
-
Posts
-
Re: Bosch SGS45C02GB/06 D/Washer just keeps filling
impellor jug every time change it, or the reed switch , also solder the 2 wires to the impellor jug some time does the trick
philRe: Bosch dishwasher
original fault was the same as now going through with out heating , its driving me nuts .
will get back to you with the enr number again when i get in work to moz
this dishwasher is 4 to5 years old , customer says ony uses it 3 to 4 times a year partys chrimbo it is spotless i must say . thanks for the help so far .phil
Re: Bosch dishwasher
yes configured pcb ok , only £60+ from qualtex , heater matrix was a stock item
i requierd lol , fitted it to see if made any difference.yes completes the cycle i no very odd, no fault code either
filling and emptying ok , diverter working fine can here the difference in the wash
just no heat , carnt get a live to any part of the heater matrix so i think faulty pcb.enr 10306160231184320156
Re: Candy cdi1012/80
hope this helps
look for rub marks on the frame work ..just in case a broke the rules of coppy rite heres a link to it lol http://imageshack.us/photo/my-images/855/dishp.png/
phil
Re: hoover hdb854d-80 e11
dry joint on dryer module if its got one , or dryer module gone
its the little one below the back panel
hth phil poolealso came across this while reseaching some thing else
We realized that the most frequent
reason for the trouble quoted in
subject, is a defective continuity of
the AMP terminals fitted onto the
leads of the NTC Temperature Probe
for Drying. The reasons for their
failure can be many and varied
(vibrations, overheating, rough
treatment while servicing), until the
said AMP terminals get ultimately
spoiled, this triggering the displaying
of the error for the open circuited
NTC Probe for Drying NTC (E11Re: hoover washing machine program fault
i will go with Martin on this one usually selector switch 🙂
Re: Hoover OPH616/2-80 lifter needs replacing
suedehead1 wrote:i dont like to disagree but its the curved paddle and it just clips on.
yes correct just done one lolphil
Re: hotpoint indieshit
suedehead1 wrote:just read that other post what a palaver, why do they always have to make things difficult.
customer tips machine back to drain water out of filter, removes blockage, puts filter back in.
then machine not working. Do the designers of washing machines no nothing about what happens to them in the field.well it seems you have hit the nail on the head . tried every thing in the book , blocked pump on a aqultist 8kg had to get my hotpot engineer come and reset pcb all fixed now .
i really think this just un fer lol
some one let me loose with a hotpot hard drive lol rip it rite to peaces ??????????????? :rotfl:
