[loopey]

Re: Schreiber apm6855 f/f

ok found fan had gone o/c fitted new fan , still wont run fan . thinking pcb has gone aswell , freezer down -28 fridge +4 . any advice please

[loopey]

Re: ATAG fridge

magnet in door reed switch on cabinet i think , but not sure

[loopey]

Re: Bosch D/W SGV53E03GB/74 “Staining”

Iff its a diverter motor failure , put a fiver on it .. just unclip the motor replace with
indesit slave timer motor , much cheaper way of fixing it ….

[loopey]

Re: Bosch SGS55C02GB/01 Classix Dishwasher CHECK WATER

other likely suspect is a dirty water jacket , top left hand side gets full of gunk , just pore boiling water down it a couple of times should clear it 🙂

[loopey]

Re: Whirlpool AWM5104/4 RCD triping out

meggar the ntc even though its plastic , i had the very same fault on a diferent m/c , or pull the leads off and try again , changed ntc FIXED
it good and proper …

phil

[loopey]

Re: ariston cooker tc714

there should be 2 simple relays , just short out the to leads together, to the corresponding relays job done . the other 2 leads are the the live and neutrol to the timer …………………..

[loopey]

Re: Bosch dryer

ok thanks guys will go put it back together lol see iff that works ?

Sorry no still the same any other suggestions 🙂

[loopey]

Re: NEFF intergrated washer

wow thanks guys for replys , cutting clips off now , cheers

[loopey]

Re: baumatic 1000w microwave

ABNORMAL MESSAGE
• “TEMPERATURE IS HIGH” message will be shown when the
inside temperature of the oven is high before selecting defrost or
40°C convection mode.
• To get better cooking result, the oven needs “cooling”.
• If the inside temperature of the oven is higher than expected or the
temperature sensor doesn’t work properly, “ERROR 2” message
will be shown in the display.
• Unplug the power and call our technical service.
• When the temperature sensor is disconnected, “ERROR 3”
message will be shown in the display.
• Unplug the power and call our technical service.

hope this gives you some were to start with .

[loopey]

Re: Hotpoint WD420

wash thermister open/short circuit , check connections and thermister ..

🙂

[loopey]

Re: HOTPOINT DISHWASHER

well just try it , have done this a few times and its worked 🙂 the only other thing is the pcb may not be programed had that in the past ..

[loopey]

Re: HOTPOINT DISHWASHER

software recognition error replace timer ? either wrong pcb or try taking pcb off then leave it half an hour and refit n some times works ..

[loopey]

Re: lux fault code E41

door interlock or catch or main pcb ,not locking 🙂

[loopey]

Re: WT960 bag tie

yes seen the bag tie on the wf range a few times now

[loopey]

Re: FF73P fridge warm

possabley to much weight
in the door bringing the light on , easy to miss that one

[Author]

Posts