Forum Replies Created
-
Posts
-
Re: Samsung RL41SBTB Chemical Smell?
Check the compressor ptc relay had one do this when got down to temp and switched off relay would smoke for awhile giving off a bad smell changed ptc all ok again
philRe: HOTPOINT WIL103UK (313030)
yes … You will need a Smart card reader + Smart Card Low End Adaptor + the correct smart card for that model
phil
Re: Horrible BF41!
Iff its got a plastic lower wash arm see iff the ends have split at the seem
Had this a few times now… replace arm with the metal type one .. 🙂phil
Re: Elactrolux ESL63010 Dishwasher Dead
yup pcb gone , have a look at the blue transformer on pcb iff its got an oval top , its gone , it should be flat .this can be changed done it a hundred times ,,
phil
Re: Hoover Nextra hnc175 dryer thermostat
have been using this p/number hoover 40001753 1 shot stat
phil
Re: Candy washing machine part number
41014472
41015028
41005128
these are all i can find hope this helpsRe: panasonic inverter
Well i finaly cracked it a little over site again , it was the cam on the air flow flap had melted it was not energizing the micro switch ,
Re: ZANUSSI MICROWAVE ZMC30STQ
lickley suspect is the magnetron , had a few of thows lately , take mag off
give it a gentlle shake listen for a rattle , intermittent loose filament
philRe: Schreiber apm6855 f/f
thanks funkyboogy over looked that one , reed switch was gone 🙂 cold in fridge now 🙂
Re: panasonic inverter
bzz67 wrote:if you call paul at AWI, he has great knowlege on all these (01983 0817220)
sounds like an inverter fault to me.yer paul was my 1st call , still wating for a call back , have fitted 3 mags to it now 1 from a repair that came in that i no that works and a new one from stock and a good s/hand 1 , all the same cuts out at 30 secs , this gets worse i fitted inverter board to it and its the same :bang:
thanks phil
