[monkey]

Re: AEG L16830 Dryer cuts out

condenser valve is ok.

[monkey]

Re: Bosch SGS53C02GB flood protection

thanks guys.I will go back and have another look

[monkey]

Re: zanussi TC7114W water valve

thanks

[monkey]

Re: zanussi TC7114W water valve

it is the machine end

[monkey]

Re: hoover logic A3794 f6 fault

thanks
I am going back tomorrow to have a go a it
monkey

[monkey]

Re: Whirlpool AKZ151/1X wont move off stop

I changed switch because it was sticking.But after I changed it I found it had not fixed the problem.

[monkey]

Re: Whirlpool AKZ151/1X wont move off stop

thanks
when you press the button nothing is happening.I have tried pressing it 3 times.

[monkey]

Re: whirlpool AWG349/3 programmer advancing

thanks
It is a built-in appliance so I was after a few tips before pulling it out.

[monkey]

Re: Zanussi zhf470x Grill/top oven switch

thanks monkey

[monkey]

Re: whirlpool 3lsc8255eq1 toploader no spin

I have read the thread but it does not tell me how to change the clutch.Can you give me any advice.

[monkey]

Re: whirlpool 3lsc8255eq1 toploader no spin

can you give me some tips on how to replace the clutch or better still if you have a manual

[monkey]

Re: hotpoint wma44 flood protection

It still as the moulded plug on.I spent another couple hours on it again today. I tried cleaning the sump out and tried a new pump.When it fills you can hear the pressure switch click but it just carries on filling into flood protection. I have checked the cables from the pressure switch.The only thing I have noticed is when you set a wash program, the wash light and the rinse and spin lights are lit as well. I think I will give up on this one.

[monkey]

Re: hotpoint wma44 flood protection

I took the motor out through the bottom,although I did tip the machine onto it’s side. it seems like it is not clicking off at the first level and just filling to far till it reaches flood protection. I am going back this morning to clean the sump in case it as slight blockage and the air is rushing into the pressure switch all of a sudden and activating flood protection.

[monkey]

Re: hotpoint wma44 flood protection

I have doubled checked the wiring and everything is in place. It will work ok on the spin

[monkey]

Re: smeg DI612CA flood protection

Thanks I have got drawing.When I called back and checked the pressure switch it as got a pipe coming out of it, I could not see it because it it comes out the top. I checked the pressure switch it seems to work ok.When you start the dishwasher everything seems to be working ok but it wont stop filling, you can hear the pressure switch click. I have checked the cables up to the module they are ok, all I can think of is the module must be faulty.
I would appreciate any help.

[Author]

Posts