monkey

Forum Replies Created

Viewing 15 posts - 16 through 30 (of 80 total)
1 2 3 4 5 6
  • Author
    Posts
  • August 23, 2010 at 9:22 pm in reply to: Bosch WFO2467GB/01 spin fault #328093
    monkey
    Participant

    Re: Bosch WFO2467GB/01 spin fault

    the brushe have not been changed, they are ok. It stops at the same time every time.

    July 4, 2010 at 10:38 am in reply to: Whirlpool AKP951ix top oven door #324527
    monkey
    Participant

    Re: Whirlpool AKP951ix top oven door

    I put the part no. into connections the glass is the same price has a complete door. Can you tell from drawing if they do a complete door,because it comes up on connections has a complete door.

    July 3, 2010 at 6:56 pm in reply to: Whirlpool AKP951ix top oven door #324525
    monkey
    Participant

    Re: Whirlpool AKP951ix top oven door

    The customer said it is the middle glass that is broken

    June 20, 2010 at 1:01 pm in reply to: Hotpoint FF175BP fridge too warm #322319
    monkey
    Participant

    Re: Hotpoint FF175BP fridge too warm

    I have tested heater in tested ok 300 ohms,the black and orange cables i got 6k and grey and blue .1 ohm,which I think is ok.do you have any ideas it is a defrost problem because there was a lot of ice.i noticed that there is another sensor attached to the inner lining below the evaporator.

    June 6, 2010 at 3:30 pm in reply to: Zanussi ZWF1632W wont start #321746
    monkey
    Participant

    Re: Zanussi ZWF1632W wont start

    it is not coming up with a code, it jumps straight to the end light.

    October 31, 2009 at 8:58 am in reply to: teka dw6 59 fi button selector not working #282011
    monkey
    Participant

    Re: teka dw6 59 fi button selector not working

    If you cant select a program it normally has a earth fault

    October 6, 2009 at 9:02 pm in reply to: Hotpoint DF61 Circulation pump #298847
    monkey
    Participant

    Re: Hotpoint DF61 Circulation pump

    do you know the part number for the bosch version

    September 20, 2009 at 4:27 pm in reply to: Diplomat AHY4420 Thermostat #297440
    monkey
    Participant

    Re: Diplomat AHY4420 Thermostat

    thanks guys
    but do you have a part no.

    April 19, 2009 at 3:22 pm in reply to: Smeg CR330SE Drain tube blocked #283096
    monkey
    Participant

    Re: Smeg CR330SE Drain tube blocked

    It is blocked about 24 inches down the tube.

    April 18, 2009 at 7:37 am in reply to: Smeg CR330SE Drain tube blocked #283094
    monkey
    Participant

    Re: Smeg CR330SE Drain tube blocked

    sorry I should have said,it is the fridge drain tube that is blocked.

    April 18, 2009 at 7:36 am in reply to: Miele T5213 Finish Light #283287
    monkey
    Participant

    Re: Miele T5213 Finish Light

    thanks guys
    You can hear the relay clicking, but nothing happens,the door switch looks like it is one unit.
    Any more suggestions?

    April 6, 2009 at 5:58 pm in reply to: Samsung RS20CCMS defrost heater #282098
    monkey
    Participant

    Re: Samsung RS20CCMS defrost heater

    It is the one at the bottom,which part no. is for the bottom one?

    February 19, 2009 at 9:04 pm in reply to: Whirlpool ADG7550 4 flashes #277715
    monkey
    Participant

    Re: Whirlpool ADG7550 4 flashes

    It fills ok, so do you think it could be the flow meter, my experience in the past is when the flow meter is faulty they dont fill properly. I have checked the gauze.

    December 4, 2008 at 8:27 pm in reply to: whirlpool AKZ451/x/01 85845115075 #270485
    monkey
    Participant

    Re: whirlpool AKZ451/x/01 85845115075

    s/n 140713027954

    November 24, 2008 at 9:56 pm in reply to: MIELE G638 Overfilling #267116
    monkey
    Participant

    Re: MIELE G638 Overfilling

    thanks.
    I called back and checked pressure switches, they seem be ok. what I have noticed is that it starts to fill as soon as you power the dishwasher up.

  • Author
    Posts
Viewing 15 posts - 16 through 30 (of 80 total)
1 2 3 4 5 6