Forum Replies Created
-
Posts
-
Re: Siemens D/W Dispenser ?
Diagrams on http://www.bshcustomerservice.com show three components as 182136 – not terribly clear what they are – lid, actuator rod and something else….
Got to be a reasonable punt, as there is no specific spring shown at all.
Chris.
Re: Football season 09/10
Poor, wasn’t it? Oldham fared no better….
I got so bored I went and nobbled about 20 spammers….
:p45:
Re: In search of the fourth cord
Lee8 is being a t!t again…..
http://www.ukwhitegoods.co.uk/modules.p … 7&start=15
lee8 wrote:The fact something needs defending indicates how bad it is. 😆
I`d suggest if your taking 10 minutes on a Samsung mod, your not doin your job properly. :rolls:
Which I have taken the liberty of editing….
Chris.
Re: AEG L16830 display time reseting
Zanussi in a dress – this may well be an earth leakage problem. Try disconnecting the leads to the dryer elements and see if she’ll run. Wash heater and motor earth leaks can cause similar corruption problems. PCB itself may be corrupted. Try the dryer heater first – it’s quick and easy.
Power off first.
Penguin45.
Re: Smeg DWI612C Possible PCB fault
A regular pulse from the drain pump and no other action is always a pcb fault.
As one of the authors of The Article, I’m surprised that it should be considered “infamous”. All we have doen is put the information into the public domain.
Penguin45.
Re: Comet In Financial Trouble?
Ill-considered posting, probably. The relative low numbers of posting company engineers as opposed to the large number of active independents leaves them as a bit of a soft target.
Fear of the employer is still a real threat.
Chris.
boselecta wrote:Keep in mind Comet are the only company who service all appliances within guarantee. By all appliances I mean all manufactures and the full white good set, so a good Comet engineer is top of trade in my opinion.
Bit of perspective, Helo – you’ve got at least two on your side.
Chris.
Re: Diplomat AMP 8702 Washer Dryer – motor sticking
Induction motor on this machine, so no brushes. It does, however, use a capacitor to “kick off” the motor. This gradually lose the ability to charge, so the motor will labour or stall.
Selection of capacitors HERE – yours will be either 18 or 20uf.
Stay safe, power off.
Penguin45.
Re: meggers
Interesting point – consider – your MoT certificate, whilst valid for a year, is only accurate at the point at which it was signed – it is immediately out of date when you drive off.
Penguin45.
Re: AEG Competence oven
Usually THIS LITTLE CHAPPIE is the culprit. Switches cooling fan on. If it doesn’t, overheat stat shuts the oven down.
It’s under the top cover panel – power off first.
Penguin45.
