Forum Replies Created
-
Posts
-
Re: Bosch dishwasher tray
You shouldn’t need to “access the plate”. Model info is either engraved on the top edge of the inner door panel or on a label on the casing surround up at the top just below the lid.
Numbers given are insufficient to access the Bosch database.
Regards,
Penguin45.Re: Embarassing Bosch question
Long ago, in a post on UKW before ISE began, one of the BSH lads said that it was the way to do it…… All you’ve got to do is drain the matrix and it won’t flood anyway.
Chris.
Re: Anybody heard of a BALAY T8233 washer??
Balay is the Spanish end of Bosch.
Door actuator, on/off switch and door cable assembly – p/no 095317.
Chris.
Re: The Weee Directive
Type “WEEE” into the search facility – been a fair bit of discussion over the last 2 years.
Chris.
Re: Beko DW D3241FW advances thru prog’
If it washes for a while, then sets off round the rest of the programme it’s the NTC at fault. P/no BE1884400100 – £5.50 from SEME.
Chris.
Re: Watch out for this one…
Goatboy wrote:I’m on Thunderbird at the mo.
God, that’s rough stuff to drink…..
Chris.
Re: diplomat model APM8722 problems
Perfect timing then….. 😀 .
These machines are largely found as freestanding appliances, badged as Servis. A check back in the forum will give some idea of the problems people face. TBH, mechanically they are reasonably robust – it’s the control circuits that seem to suffer – computer boards seem to be the real weak spot.It’s always a problem with buying a “branded” appliance – you don’t always know what you are getting. Next time, stick to a name you recognise.
Regards,
Penguin45.Re: Fisher & Paykel 608 stops at spin cycle
Um…….. 10001000 is a motor stall fault – it’s jammed somehow. 1010000 is the bowl now being stuck in the engaged mode when it should be allowing agitation. 10010000 isn’t a valid code.
If turned manually, the drum does spin freely?
That’s about as far as I can go – Kiwi and F+P check in regularly, so if this doesn’t help, don’t panic – they’ll pick up on it.
Regards,
Penguin45.Re: F&P Smartdrive – Does’t Fill on Startup
Nope – none of these correlate either – so………
No fill is caused by:
Valve failure – if it fills in test mode this is not the case.
Pump failure – try running a drain sequence only.
Rotor position sensor failure – it should agitate during fill.
Lid switch failure – shouldn’t do anything at all.Kiwi and F+P check these forums regularly and have a lot more experience than I, so if none of the above helps, don’t panic yet!
Regards,
Penguin45.
