Forum Replies Created
-
Posts
-
Re: On Board
Please post mobile phone number so that we can ring you at 2am to tell how good the bar is…….
Chris.
Re: Smeg DW1612C suspect control board?
ChrisK wrote:Or perhaps putting a washing machine inlet solenoid in circuit instead?
That’ll work for testing purposes.
Penguin45.
Re: HOOVER HNMF
I sent it to the one in your profile. Please advise if that is correct or not, as I have a bounce notification.
Chris.
Re: September meeting @ coventry hilton hotel
A1engineer wrote:I’ve been assured they don t bite tho
Much……… 😆
:p45:
Re: Hoover HNL 6166 DOOR LATCH
The “U” goes behind the latch, the pin goes through the loops and the tails press against the door panel.
Penguin45.
Re: Indesit WIE137 s uk “DOOR” error
If the door is locked, but the “Door” error is showing, the computer doesn’t realise that the lock is activated and is therefore faulty.
Penguin45.
Re: Teka ls1000i stalls mid way
Try 92208156 for the timer from a wholesaler who won’t rip you off.
Module is 91964239, but I’m pretty sure that’s just a motor board.Chris.
Re: Hotpoint WF865 will not stop spinning & loud clicks
Computer. Pay The Indesit Company £100 under your 5 year parts guarantee and get it fixed is your cheapest option.
Or replace.
Penguin45.
Re: Hotpoint WMA46 problems
Short circuit door lock blows pcb.
Short circuit heater blows pcb.
Short circuit motor blows pcb.
Short circuit pump blows pcb.
Wiring chaffing on front weight creates short circuit and blows pcb.
Wicked Witch of the West turning round three times creates short circuit and blows pcb.
Penguin45.Re: Indesit WIL103 Fault Lights
If the motor is not running under proper control, the drum will bang about all over the place.
See Iadom’s first reply.
Penguin45.
Re: Whirlpool 957
You’ll need THIS. It guides the strap from the spring to the door and is prone to collapse. No “how to” guide i’m afraid, but it’s pretty obvious once the side panel is removed.
Power off first, please.
Penguin45.
