Forum Replies Created
-
Posts
-
Re: Whats the most annoying thing customers do?
I’d check your third party liabilty insurance very carefully before getting into that sort of stuff. Mine says “household appliances only”. When I checked with them, I’m not covered for minor plumbing or electrical work.
Chris.
Re: Whirlpool ADP 4504 ‘pulsing’ problem
Actually, it’s not that bad. The PCB is p/no 4812 218 38209. My tech disc suggests about £75, BUT, it is 2 years old, so there has almost inevitably been a price increase. Contact spares@ukwhitegoods.co.uk with the part number for current prices and ordering.
Be very sure that this is what you need – it won’t be a returnable part. You should check under the dishwasher for leaks and burnt wiring, as well as continuity through the heater first.
Stay safe, power off if working on the machine.
Penguin45.
Re: Bosch WAA24160GB/01 what size bearings do I need?
Don’t forget your hacksaw and some longish No.8 self-tappers……
Chris.
Re: Zanussi/AEG tumble dryer belt tension pulley clips
A belt under tension running on a curved surface will self centre the curved surface…….
Chris.
Re: Whirlpool ADP 4504 ‘pulsing’ problem
Sounds like a classic pcb corruption issue to me. Likely to be very expensive. If you post up the 12nc number (The one that starts with 8), I can identify the part number for you.
Penguin45.
Re: caple dishwasher
It’s a SMEG and that sounds like a classic corruption issue. Mains suppressor and dodgy dispenser solenoid are both suspects, as is the pcb itself.
Chris.
Re: caple dishwasher fault codes?
It’s Chinese, so the Haier codes will apply. Doesn’t follow that they’re accurate, though.
Chris.
Re: Hotpoint df23 heater ceramic and grommet
Granvilles PetroPutty – from all good motor factors. 😀
Chris.
Re: Diplomat APM 8552 Faulty timer ?
Bottom of the rear panel on the drum. You’re looking for 25ohms(ish) on your test meter.
Stay safe, power off first.
Penguin45.
