Forum Replies Created
-
Posts
-
Re: Bosch Condenser Problem
Remove lid and plug. Find where up-pipe from pump joins drawer. Clean out spout.
If that doesn’t do it, find the model number……..
Penguin45.
Re: ISE AW23
There’s nothing in the user book about how to set the delay start.
I’ve figured it out, but there’s nowt in writing.
:p45:
Re: Hotpoint WML520P Leaking from Drawer
daisychain wrote:It starts to leak when the cycle is on the spin and pump out of the wash.
Partial blockage……….
Penguin45.
Re: Bosch SRS43E02GB problem – stops mid cycle with no power
On/off switch is an obvious candidate but in my experience an unlikely one – generally very reliable. Some sort of break down in the pcb is a far more likely option. May be worth checking for burnt/cracked/dry solder joints on the pcb, but I wouldn’t hold out too much hope,
Power off if doing this yourself.
Penguin45.
Re: AEG induction hob.
Hi Steve,
From what I can see, it’s bad wiring, bad ventilation or bad pcbs. Got a model number?Chris.
Re: electrolux automatic defrost F/F Er8034I
Sent you some stuff. You won’t like it very much………
Chris.
Re: program 2000 APDW/2
Remove lower cover plate and plug. Nice big towel handy and bend down the front edge of the tray is the quickest way.
Penguin45.
Re: Machine Identification Required
APR shortens the wash by two “clicks” and adds an extra rinse instead. I take it that you have done the basics – removed and cleaned the filter and checked the sink coupling is clear?
Penguin45.
Re: F+P Smartdrive 501 – error code 00010000 – spin problem
As far as I can tell, there’s a problem with the communications between the electronic boards. F+P suggest unplugging the machine and leaving it for a while and seeing if it clears. Otherwise, you’re probably looking at replacing the displat board.
Penguin45.
Re: Zanussi FLA 1201W lost its ooomph in the spin cycle
1/ Filter clear?
2/ Carbon brush drive motor – brushes may be worn.
3/ Water level control system may be sludged up, causing the machine to think it’s full when it is actually empty.Deal with the first two first. The third ones a bit complicated.
Power off if you’re going in…….
Penguin45.
Re: program 2000 APDW/2
Flood protection activated. Base tray under machine is probably full of water. Drain it to reset the machine. If you get a recurrence, you’ll need to find the leak.
To reset the computer, press and hold the start button.
Power off if you intend to investigate this yourself.
Penguin45.
Re: Machine Identification Required
Nope……..
It’s just a Merloni-built washer – what do you want?
Penguin45.
Re: april fools day…..ive a washer in my shower room ..!!!
S@d the regulations – you’re faced with a machine dripping with condensation – it shouldn’t be there.
Chris.
