Forum Replies Created
-
Posts
-
Re: Lifting up washing machines to rear of van?
There is a thead somewhere about this and I’m d@mned if I can find it. Very simple and very ingenius. Martin may have contributed…
Any ideas, Martin?
Chris.
Re: Very old junior
Amazing what’s still out there for these.
THIS LOT seem to cover all the bases for you.
Penguin45.
Re: indesit wdryer wd12
The pot state is a thermistor or “ntc” device. If you split it from the circuit, you should get a reading through it in kOhms. If you then heat the device, the resistance should fall. If there is no circuit, you’ll get F13.
The microtemp is just a thermal fuse in line with the heater. If either fail, you will not get an error code at all.
Chris.
Re: Kupperbusch dishwasher igv659.2 failing to work
It’s a Bosch in a dress. Standard fault is underfilling, lots and lots of threads detailing this problem through the forum.
Penguin45.
Re: Zanussi DCS 12W – Tabletop Dishwasher Not Draining
Pop a couple of towels down and lay it on its side is probably the easiest way.
Penguin45.
Re: creda simplicity. washer, w100fw
Probably…. Get the tester on it – or just disconnect the heater and see what happens.
Chris.
Re: Zanussi 1397 spin/no spin problems
Positive Mental Attitude – good…. 😀
OK, understand that the water level switches are operated by rubber diaphragms, which are pushed over by the displacement of air trapped in the pressure chambers. Chambers get choked, weird stuff can start to happen.
The skinny hoses are usually retained by small spring clips, which can be grabed and moved up the hose with pliers, you the need to lever the hose up the spigot with a flat bladed screwdriver in order to break their seal.
Penguin45.
Re: DES 959 AL6
AL6 is no drain detected in the time allowed. If it’s full of water, you have a blockage or a pump failure. If it’s empty, there is something wrong with the water level control system – which could relate to the IWMS.
Power off if you’re sorting this yourself.
Penguin45.
Re: CDA CW447
It looks rather like the usual Chinese tat, unfortunately. Black plastic inserts can be prised out and any water syphoned out (with tghe power off). It is often easier and quicker to pull the machine out and tip it to one side to drin the tray.
If it re-sets, torch and observation time.
Penguin45.
