Forum Replies Created
-
Posts
-
Re: indesit
Circulation problem. Model number is crucial – check round the edges of the door.
We’re all guessing, otherwise.
Penguin45.
Re: Bosch SGS3062GB/02 not draining
Bail out as much water as you can. There is an access panel in the left hand side of the floor of the sump. Remove the screw and lift the panel away to get to the pump impellor.
Penguin45.
Re: Diplomat (Whirlpool) ADP8322 integrated dishwasher
Look on your invoice for the part number, Jonty.
Chris.
Re: Diplomat (Whirlpool) ADP8322 integrated dishwasher
You should have pcb 4812 218 38381.
If you have 4812 218 38347 the pcb is not configured.Chris.
Re: Hotpoint WF 860 – wont finish – stops on 1 min to go
Used correctly, ‘Search’ brings up 5 results:
THIS ONE is the most relevant.
Chris.
Re: Zanussi TC7103 condenser dryer not heating
P/no 1258406-01/4 if it’s o/c. spares@ukwhitegoods.co.uk will get you one promptly.
Penguin45.
Re: Neff S5443x2GB/42 Lower Arm not rotating
Motor is driving a gear train – unfortunately any component could have failed. BSH only supply the heater assembly, I’m afraid.
Penguin45.
Re: Whirlpool ADG9442 Error flashing 4 now flashing 2
4 flashes is drain not detected in the time allowed. If you are certain that the grid is not gunged up, then the microswitch has probably failed. You’ll need one of THESE. That is the manufacturers part number, so you may be able to source one locally. It’s a twist fit from underneath.
2 flashes is the overflow problem. If the level switch is not working, it may have overfilled and leaked into the tray under the machine.
Power off before removing any panel,
Regards,
Penguin45.Re: In search of the fourth cord
Another nutter…. :rolls:
dishwasherfettishist wrote:I think your problem here is a lack of TLC. You strike me as a poster who doesn’t care too much for their machine, probably even abuses it slightly (and I don’t mean in that good way that some of us like to! wink wink,).
Try looking in the flugglebungsinkhole, you may have had a build up of funky-dredge-weed – a common problem with this machine being used by amateurs.
Remeber, most importantly of all, a few nice words and a caress with a wet shammy will work wonders on most white goods, and can be as much fun for the operator.
Locked him out.
Chris.Re: cda dishwasher big askoll motor problem
Whirlpool in a dress – classic pump failure – article HERE.
Duplicate post deleted.
Penguin45,
Moderator.
