Forum Replies Created
-
Posts
-
Re: Bosch wfl 2260
Right – that version has the two part “clam shell” tub and uses THIS BEARING KIT.
It now becomes a complete and total evil swine of a job. Tub must be removed and split to allow access. As a repairer whose done this before, I can do it in about two hours. If it’s your first time, I’d allow Sunday for the job.
Sorry about the confusion.
Penguin45.
Re: Hoover visionHD 8kg VHD 816
Tacho magnet and coil will have fallen off the end of the drive motor.
Power off and lean back for access.
Penguin45.
Re: Creda Concept ceramics – door handle
P/no 6201943 – email to spares@ukwhitegoods.co.uk for prices and ordering.
Penguin45.
Re: Creda Concept ceramics – door handle
Model number please, Flyer. 4—-
Some of the older ones are going obsolete, so the number is crucial.
Penguin45.
Re: Whirlpool ADG7540 cold wash
Door would be transferable using the fittings supplied with a new appliance.
Yours will come off if you slacken screws 2 + 4 by two turns down each side of the door – mind your toes….
Penguin45.
Re: Myson Boiler problems
Sorry, Joey, we’re not allowed to help you.
1/ This isn’t a whitegoods issue.
2/ We cannot advise you on any gas issues due to safety implications.We can only direct you towards your local Gas Safe engineer.
Good luck with it,
Penguin45,
Moderator.Re: diplomat APM8702 washer/dryer – how remove detergent dra
Hook your thumbs into the corners of the drawer and pull hard. Do not pull it by the front piece – it will break.
Penguin45.
Re: Looking to buy a m/c -advice plz
Iadom put the bottom line at £350, £300 is not so bad. Personally, I wouldn’t have a current Indesit Company product given, let alone pay money for one.
The Bosch machine listed has a sealed tub, so bearing failure would require a replacement assembly. The Whirlpool I can find no info on. They’ve always been reasonably decent in the middle ground, although the spares pricing policy can often be described as larcenous.
However, I’m a repairer not a retailer, so hang fire ’til the morning. Don will be able to give you a rather more reasoned assessment of machines in your price bracket.
Penguin45.
Re: Smeg DWI612C error code e3
Nicely done – odd fault with a SMEG.
To fix this properly, do not just remake the break at the pivot point – it won’t last long. You need to chop out the broken wire and insert a new section joining above and below the pivot point for a repair which will last.
Penguin45.
