[pmb]

Thanks for the advice

[pmb]

Hi Dave, unfortunately I need a new megger after my van got broken into. I am making do with a circuit tester while I organise a new one.
I think I will order and try a new heater

[pmb]

Thanks Dave much appreciated

[pmb]

Thanks Dave

[pmb]

Thanks Jem I’ll give that a try

[pmb]

Thanks for checking Dave
I’ll probably just order it, it might be obvious or have instructions

[pmb]

Thanks a lot Dave, I will check those out

[pmb]

Hi I have done a few, they are fiddly but easier than taking the bottom to fit it.
make sure you cut away the excess plastic as shown in the instructions.
Put washing up liquid around and be careful not to slice the seal on the sharp edges around the screw holes. You have to push the sump around to make space for the seal.

[pmb]

Great thanks I’ll try that

[pmb]

Thanks for getting back to me Dave.
I cleaned the condenser from front to back, but not the side I didnt realise I should.
yes I checked the cold air fan.
I’ll download the manual and try adjusting the dryness.

[pmb]

Hi again, I am still having problems with this one. I have replaced the front NTC now as well as the back. I have checked the wiring from the PCB to both sensors.
I don’t see how anything I did could suddenly cause this fault, I have repaired loads of these WTE dryers.
has anyone got a suggestion?
Thanks, Darren

[pmb]

I haven’t, I should have though good thinking.
thanks

[pmb]

Thanks for your help Dave

[pmb]

I am talking about closing drum not the top lid

[pmb]

Yes that’s how it seems, it’s a burst of water roughly once a second which leaks even if turn the tap for the water supply very low.
Its really strange

[Author]

Posts