Forum Replies Created
-
AuthorPosts
-
pto
ParticipantRe: ise
well it needed an inverter board and you must know its not available , and no not at this email and it was 2year 3 months when it went duff and yes £100 in a cheque
pto
ParticipantRe: Faulty wash cycle on Servis Quartz.
no earth on new filter
jack
July 17, 2007 at 11:07 am in reply to: For whom the Beko tolls, it tolls for me. (Arghhhhhh) #221282pto
ParticipantRe: For whom the Beko tolls, it tolls for me. (Arghhhhhh)
WhirlpoolQueen don’t knock beko what do you think an ISE is
One of turkeys finest straight out of the beko factoryJack
May 12, 2007 at 6:43 pm in reply to: 3 ENGINEERS LATER AND STILL NOT WORKING CAN ANYONE HELP #211796pto
ParticipantLike I say three weeks and no joy then they aren’t engineers
They may say they are but we know better don’t weMay 11, 2007 at 9:29 pm in reply to: 3 ENGINEERS LATER AND STILL NOT WORKING CAN ANYONE HELP #211794pto
ParticipantLets face it you haven’t had a engineer round yet or it would be working by now
April 30, 2007 at 8:16 pm in reply to: ‘B’ grade hotpoint washers sold as ‘A’ grade on internet #207101pto
ParticipantRe: ‘B’ grade hotpoint washers sold as ‘A’ grade on internet
are any hotpoint washers a grade these days?
pto
ParticipantRe: Can you recommend me a new washing machine?
Siemens to hoover come on thats a joke
is it?Jack
pto
ParticipantRe: Zanussi WDJ1294 Door Gasket issue
Fairdeal wrote:Paul wrote:
I am afraid changing gaskets on the Zanussi Washer dryer or even the washers is not easy.You normally have to take the whole drum out to put the gasket in.
Regards
What. No waypto
ParticipantRe: Bosch KGV3120GB/01 Switching Problems
boro wrote:
😕 Why do that, the by-pass kit takes all of ten minutes to fit :zap:boro wrote:The repair is NOT expensive. A competent engineer will have the job done in under half an hour.
.10 mins 30 mins ?
pto
ParticipantRe: Bosch KGV3120GB/01 Switching Problems
boro wrote:
😕 Why do that, the by-pass kit takes all of ten minutes to fit :zap:boro wrote:The repair is NOT expensive. A competent engineer will have the job done in under half an hour.
.10 mins 30 mins ?
pto
ParticipantWell if I repeated it that would defeat the deletion but basically it entailed hacking into a fridge insulation which seemed a tad excessive. If you can be bothered to use the search facility you may even find the mod has already been mentioned previously
Not hacking into the insulation but to cut carefully a 2ins x 3ins
Hole and slip a new thermistor in placeIts about £12 p/no 491416, so not too bad.
What do you get for your £12 one connector that’s bad
I bet no one on here buys two kitspto
ParticipantThey do a kit but it’s just a expensive connector
And I don’t think the fridge will be as economic to run As when a thermistor is in circuit
But that’s just me thinking and it doesn’t always do
To thinkJack
pto
ParticipantPost removed by gegsy UKW Moderator
November 22, 2006 at 8:20 pm in reply to: Bosch KGN34V00 freezing up – BSH engineer confused #195458pto
ParticipantRe: Bosch KGN34V00 freezing up – BSH engineer confused
helo_75 wrote:
id be shocked if a bosch engineer was confused.. they are hightly trained, and the appliances are of excellent quality.. and in refrigeration are second to noneNot all of them from my experience
And the appliances aren’t that good these days
But the prices reflects thisJack
November 19, 2006 at 12:16 pm in reply to: Noisy Whirlpool AWZ7303 dryer – but only in one direction #195824pto
ParticipantRe: Noisy Whirlpool AWZ7303 dryer – but only in one directio
the fan
-
AuthorPosts
