Forum Replies Created
-
Posts
-
Re: Hotpoint WD440 Power Module Situation
iadom wrote:Last Friday afternoon, Indesit machine, suspected module and possible doorlock. Module posted off to EMW that afternoon.
Recieved repaired module back today with note advising of doorlock fault, fitted this afternoon, fault cleared. 8)
Jim.
i sent mine sat ,got it back tuesday,thanks to tony 😆Re: asda complaint
Martin114 wrote:might be this one…
http://www.youtube.com/watch?v=OV7SXmHq0Bk
that one thanks 😆
Re: Whirlpool Tumble Dryer
hi
that was us in bilston but i think that some one name chris is in your part of world, i try find his phone no taRe: Proline fridge/freezer
dpr1974 wrote:Well i went to see this f/freezer today, the door seal is fine and the lady has it on the lowest setting possible but it has a two inch block of ice on the back wall of the fridge. She was given the the machine when it was a week old and it been icing up since day one (18 months ago) the stat does turn the compressor off when you turn it to 0 so i suspect it had a faulty stat since new, any one agree or am i missing something? thanks
Davidhas it got a stat or is it pcb
Re: Hotpoint Aquarius 1000
What does your megger say? as Phidom says the spider may be cracked and damaged the heater although they would have complained of it being noisy on spin, check the insulation with water in the machine, fill it by hand to be on the safe side :wink:[/qu
what a megger? 😆
Re: Hotpoint VTD20 tumble drier.
A1engineer wrote:instead of a big screwdriver i use a extending bar with a big socket loop through belt and push socket into motor shaft, pull down and work belt off bar and onto motor.
kev
or use the hotpoint belt tool which is essentiallty the same,
i use copper pipe works well
Re: hoover/candy int f/f fridge thermistor
Penguin45 wrote:Info sent to both of you. Have fun…..
Chris.
hi chris
can you pls send me info as well, thanks
