[pup]

Re: candycfmf 235-a-89 overfreezing

loopey wrote:pup sent you a little info 🙂

thanks for that but still cant find the sensor . 😥

[pup]

Re: candycfmf 235-a-89 overfreezing

have dug out foam 168mm down 172 across but cant find any sensor at
help 😥

[pup]

Re: candycfmf 235-a-89 overfreezing

hi done that and cant find them

[pup]

Re: hoover vhd 862 1600 spin excessive vibration on spin

drum spider?

[pup]

Re: ZANUSSI ZWD1271 RESETIING ITSELF

have checlk the heaters?

[pup]

Re: seized/broken isolation valves

Simon_ wrote:Get the sink taps on also, reduce the pressure a bit. After a few soakings i have learned to find the taps before pulling out machine.

and me to 😆

[pup]

Re: repairs@

andy_art_trigg wrote:Having to fix 10 dishwashers would be a nightmare for me – never could stand working on ’em 🙂

Good earner though hopefully?
good earner and easy jobs as welll change roller /door catch 😆 plus on going work they have 20 flats on one site 😆

[pup]

Re: Zanussi ZWF1621

Poppins wrote:Thanks Pup,

I’m going to have another look tomorrow. Did the faulty motor in question show any insulation failure? no , luckly had one in stock and did change pcb as well but no luck ,

[pup]

Re: Zanussi ZWF1621

Poppins wrote:Hi Geoff1,

Did you get any result with this machine? I am having a similar problem with a ZWF1432W. Everything else checks ok so I am suspecting it is the PCB.

Cheers
Chris
had one doing same change motor and it fine

[pup]

Re: work dead

it all dead here as well i 😳

[pup]

Re: diplomat dw,hja8630

well you have check motor ,mains filter ,ho let see pump wireing for shorting stats waterleaking, i think i cover most things 😆

[pup]

Re: zanussi z1959t bearing kit.

thik bearing are same as hotpoint wm, could be wrong 😉

[pup]

Re: Hotpoint WT960P counting down but not doing anything

MickGeorge wrote:Been to one yesterday with exactly same fault – must admit I thought was a module fault and had a word with EMW and they confirmed.

Cust was undecided what to do.

Phoned me later and had decided to get Hotpoint in to do job with a further 12mths waranty on m/c 😥 and Hotpoint were calling that same afternoon!!!

Did ask them to phone and let me know if module was the fault – will let you know

Mick hotpoint calling same afternoon looks like they not busy then 😆

[pup]

Re: EMW issues

they spot on never had bad servce and tony is always help full thanks tony

[pup]

Re: diplomat dw,hja8630

bigchrisoioi wrote:not being rude, but how can you do the job without a megger????????

should not every repair be tested? well it will interesting to find out .may be he got pat tester ? 😆

[Author]

Posts