Forum Replies Created
-
Posts
-
Re: aristonA1436/ hotpoint31193
update…spoken to customer who even after my explination about the door seal drain groove which lines up with the “missing” bit, he is so convinced that i “levered” the old d/s off and snapped the tub he has “taken advice” and contacted hotpoint and apparently “others” with a view to sue me for damaging his machine…watch this space!
richardRe: aristonA1436/ hotpoint31193
jim, thanks for the pic…re; door seal, when i ordered the door seal for an ariston A1436 i was given a seal which didnt fit, nothing like the original d/s. on the door label , where hotpoint put their label was .31194. quoted this number and got a seal which fitted exactly, only when you pull this seal from the tub do you see the cut out. 😀
richardRe: graded appliances
tony, on a bit nearer, refrigeration nw ( discount domestics) near hawarden, flintshire..01244 533857. good guys, know what they are talking about, helpfull advice. i have used them since 1999 and no probs.
richardRe: Hotpoint BF1620 Heater, where is it?
you will need a test/multi-meter to test the internal element…these are well known as a failed element. 😉
richardRe: Hotpoint Aquarius 1100 Cycle Not Completing
it may stick either due to a blocked /failed pump…does it drain out? or a faulty heater. …does it heat? put it on spin rinse and see if it drains..if it does the pump is ok.
richardRe: Bosch Classix 1200 sticking during cyle
if it doesn’t drain at the end of the wash cycle then it may be that the drain filter is blocked or the drain pump is blocked or failed..does it empty the water out? can you hear the drain pump working, is the drain hose blocked, does it drain into the u-bend under the sink. no drain no progress. 😉
richardRe: Bosch Classix 1200 sticking during cyle
when it gets to the rinse cycle, open the soap drawer a little way and see where if there is COLD water comming into the drawer.
richardRe: how to cover this
i know it’s a bit of an obvious question but did the replacement pump fix the problem?? :rolls:
richardRe: Is this a good deal?
adam, why look further than the ISE on this site? full spec and a long long parts and labour guarantee! 8)
richardRe: I want one!!!!!!!!!!!
ken, when you get a full spec and pricing info please post details abour the “homepub”..then again just order me one, or two , or three.. 😀
richardRe: Indesit bearing removal
yes, we know…and unfortunately the users know too by now..what are you going to do now?? replace or have a BASH?. if it’s replacement there is lots of info about w/m on this site, and lots of posts from users about which is the best…ie..best value, best economy rating, best results, best reliability. if you have got an independant servicing firm near you just ask..we can be a mine of info. 😉 😀
richardRe: Indesit bearing removal
the only way to get the outer bearing race out is to try , with a sharp edged chisel and endevour to shift the race by hitting chisel with heavy hammer! if you are very very lucky you could work a slot in the race enogh to move the race…be very careful as if you miss the chisel or it slips fingers do suffer, if you haven’t got an edge in about 20mins or the race hasn’t moved give up..BE LUCKY. 😉 there are no spacers to worry about.
richard
