[Simon46]

Re: siemens thermal cut out switch

ENR number would help. Result is usually a fire.

S.

[Simon46]

Re: Prima LPR450 dishwasher latch assy

Or a Belling IDW450 looks the same.

S.

[Simon46]

Re: W/Knight 767C Cond T/Dry – overheating

I was lucky. replaced the reset and the rear stat and it worked. 😀

S.

[Simon46]

Re: Prima LPR450 dishwasher latch assy

It is a 45cm Haier 🙁

S.

[Simon46]

Re: ed4 – new zannussi/electrolux W/D

Just been to one. Pumps out 5 secs stops and unlocks door. Disconnect dryer heater fills ok. Heater 1.18 MOHM.
Whats the easiest way to change htr? cabinet doesnt split.

S.

[Simon46]

Re: Tricity Bendix e710W Lower main fan oven stat

Many thanks fitted ok.

S.

[Simon46]

Re: ISE 5 PCB. Does it need configuring?

Many thanks K.

S.

[Simon46]

Re: Neff oven B1430N0GB/02 FD88002

BS14106 from masterpart is pretty good. Around £30 quid.

S.

[Simon46]

Re: Samsung SRS2029 water supply pipe

Many thanks Lerch.

S.

[Simon46]

Re: B&Q DW60bI dishwasher top spray arm

Went into comet, matched top arm with Proline DWI5212P and DWF1250P if that helps anyone for future ref.
Fitted all ok.

S.

[Simon46]

Re: Knocking Bosch.

To test if shockers smear them with grease. If it quietens down the shockers have play where the rod goes into spring unit. My wfr2860 knocks its head off with the round type. must get round to doin them. 😆

S.

[Simon46]

Re: Siemans dishwasher SN53200gb/08 fd7207 skipping heating

thanks. i tested stats as nc anyway. will remove timer to EMW.

S.

[Simon46]

Re: Whirlpool toploader not emptying

Ta Dave . The top hat on the end of shaft is ok.

S.

[Simon46]

Re: customer wants money back!!!

Pay the man the money back. You may be surprised when he rings you up in 6 months to repair his washer 😉

S.

[Simon46]

Re: Smeg DWI612C burnt PCB

I hope that this is a sometimes one 😆 .

S.

[Author]

Posts