Simon46

Forum Replies Created

Viewing 15 posts - 46 through 60 (of 2,216 total)
  • Author
    Posts
  • in reply to: Gc2224gekb fridge freezer compressor cold #455127
    Simon46
    Participant

    Re: Gc2224gekb fridge freezer compressor cold

    Thanks grendal. Will replace it.

    in reply to: Beko DW – DIN26x20 – control module #454792
    Simon46
    Participant

    Re: Beko DW – DIN26x20 – control module

    Wow.

    in reply to: Beko DW – DIN26x20 – control module #454790
    Simon46
    Participant

    Re: Beko DW – DIN26x20 – control module

    I did inspect loom covered in duct tape. Maybe it had a nick in a wire then it got wet?

    in reply to: Beko DW – DIN26x20 – control module #454788
    Simon46
    Participant

    Re: Beko DW – DIN26x20 – control module

    Ive had one of these which a previous engineer had taped up the wiring loom. Passed insulation test but when washing then failed. Pump heater ok. Condensation was getting into wiring and there were stains from the soap dispenser down the inside of the door. Cust decided to replace it so never got to the bottom of it.

    in reply to: Miele G5300 SC dishwasher – intake/drain LED #454613
    Simon46
    Participant

    Re: Miele G5300 SC dishwasher – intake/drain LED

    Yay. Glad you got it sorted

    in reply to: ZANUSSI ZWT71401WA DISPLAY FAULTY #454727
    Simon46
    Participant

    Re: ZANUSSI ZWT71401WA DISPLAY FAULTY

    Unplug dryer heater?

    in reply to: Tips, Tricks & Shortcuts #290439
    Simon46
    Participant

    Re: Tips, Tricks & Shortcuts

    Had glass in one of the plastic base bosch dishwashers and wasnt emptying. Unclipped drain pump cover ran my fat cable tie round impeller chamber. Could not get it. Pulled the mushroom up with cover off and it flicked out. Job done.

    in reply to: Bosch WFO2465GB/01 #454631
    Simon46
    Participant

    Re: Bosch WFO2465GB/01

    Ive laid a machine down on its side and had fabric coditioner all over pcb before. Now I always check the drawer.

    in reply to: Miele G5300 SC dishwasher – intake/drain LED #454610
    Simon46
    Participant

    Re: Miele G5300 SC dishwasher – intake/drain LED

    Have had a few flowmeters go faulty after being stored in garages

    in reply to: Qualtex Account Closure #443620
    Simon46
    Participant

    Re: Qualtex Account Closure

    Yes but on there public site its in stock. 1 day later its in your bin?

    in reply to: Bosch Wta2000gb/01 heater wiring #453814
    Simon46
    Participant

    Re: Bosch Wta2000gb/01 heater wiring

    You end up with a really boring photo album!

    in reply to: Bosch Wta2000gb/01 heater wiring #453810
    Simon46
    Participant

    Re: Bosch Wta2000gb/01 heater wiring

    Hang on. On my w/knight photo album I show
    Blue 1
    Red 2
    Black and black 3

    in reply to: Wet vac washing machine emptying #452769
    Simon46
    Participant

    Re: Wet vac washing machine emptying

    Phidom were you on ezee fix in the 00’s

    in reply to: Wet vac washing machine emptying #452764
    Simon46
    Participant

    Re: Wet vac washing machine emptying

    Well that was brilliant. Should have bought one 17 years ago. Sucked water out of drain hose then it ran into bowl by itself by syphon action. Finally opened filter slightly with crevice tool at base of filter and baking tray under machine to get the final bit of water out. So much faster than bowls and towels. My mum has bought one to vac the front lawn (astroturf)

    in reply to: Wet vac washing machine emptying #452763
    Simon46
    Participant

    Re: Wet vac washing machine emptying

    Good idea Tim. Maybe a baking tray on the van too electrofix. Never had to resort to this yet.
    Its the future?

Viewing 15 posts - 46 through 60 (of 2,216 total)