Forum Replies Created
-
AuthorPosts
-
Simon46
ParticipantRe: Diplomat ADP3230 inner door glass
They quoted minimum 2 weeks.
S.
Simon46
ParticipantRe: aeg santo
The ones you have seen with thermistor failures did they have the iceblock at the rear? This one has no square flashing in display and the fan appears to run and defrost drain not blocked.
Regards
S.Simon46
ParticipantRe: aeg santo
Ive got the same with huge clear iceblock down centre ducting on back wall of this larder fridge which has grown over the shelves. Any ideas on what to look at?
Regards
S.Simon46
ParticipantRe: Samsung RS21WCNS – Lower half of fridge Frozen
Fault will be back. Change evaporator cover first as R600A suggests.
Regards
S.Simon46
ParticipantRe: Neff S4453N2GB01 Semi integrated dishwasher clicking
Just wondered about this one
http://www.ukwhitegoods.co.uk/modules.p … ght=489607
S.
Simon46
ParticipantRe: baumatic/servis no spin tried module
Pressure vessel?
S.
Simon46
ParticipantSimon46
ParticipantRe: Neff S4453N2GB01 Semi integrated dishwasher clicking
is there also a coding sheet for this module? found after searching 489607.
S.
Simon46
ParticipantRe: Neff S4453N2GB01 Semi integrated dishwasher clicking
489607 module received. Mod sheet saying wire might have to be changed from pin5 to pin7 of module. Appliances up to Kl12. Also after mod special circ pump control (sicasym) up to Ki12 must be switched off.
Module config by pressing S4/S5 and switched on with HS and toggled with S4 so 1 with Sicasym or 0 without.What is this for?
Regards
SimonSimon46
ParticipantRe: Miele T220 dryer seal
Thank you so much. I really appreciate this. 😀
S.
Simon46
ParticipantRe: Miele T220 dryer seal
Thanks Seamy. Is there any hidden screws to remove front?
S.
Simon46
ParticipantRe: Hoover TC650 001 dryer bearings
Engineer that wont come back or is uncontactable by any communication device. Diagnoses drum bearings actually equals seized motor 😆
S.
Simon46
ParticipantRe: Whirlpool AKZ446
No should spin when heating.
Back to supplier.
Regards
SimonSimon46
ParticipantRe: ariston A1435s
sorry misread post. So does the door even lock at all? Reset is done by turning to the end of the program.
S.
Simon46
ParticipantRe: ariston A1435s
Unplug appliance wait 2 mins. Ensure water level is not up door glass before opening door.
Regards
Simon -
AuthorPosts
