Forum Replies Created
-
Posts
-
Re: neff s5409xogb/01 no lights on display board
thats crazy , the main power board the one on the r/h side down in the base ?
Re: neff s5409xogb/01 no lights on display board
swapped the relay , didnt work new board from my supplier 225 euro yeah roight
Re: siemens se54a535gb/08 constantly filling
slyp98 wrote:Ok removed the little float , cleaned the end of it black gunk on there , and put it back together started it up and it still took in way too much water , I then noticed the front of the dishwasher was a little lower than the back so I twisted the front legs a few turns , still running at this stage although it didn’t leak I still see too much water its up nearly covering the salt cap , any way I let it run for a further 10 mins and had another look inside to see low and behold the level had dropped all good here customer ran a cycle last night no leaks cheers
slyp98 wrote:
Cheers MartinRe: siemens se54a535gb/08 constantly filling
Ok removed the little float , cleaned the end of it black gunk on there , and put it back together started it up and it still took in way too much water , I then noticed the front of the dishwasher was a little lower than the back do I twisted the front legs a few turns , still running at this stage although it didn’t leak I still see too much water its up nearly covering the salt cap , any way I let it run for a further 10 mins and had another look inside to see low and behold the level had dropped all good here customer ran a cycle last night no leaks cheers
Re: siemens se54a535gb/08 constantly filling
just to recap , machine takes in water , the motor kicks in and the water keeps filling with the wash motor running , fills up over the top of the mushroom shaped flood device and out from the door edge seal all over the floor , i put my hand in and lifted the mushroom device and it pumped the water out , is the water fill controlled by the power board ?
Re: neff s5409xogb/01 no lights on display board
Cheers Martin, just having trouble sourcing one 9v dc switching 30v to 230v 3 amp number on body pcj-109d3mh
Re: neff s5409xogb/01 no lights on display board
anyone tried changing this relay i am talking about ?
Re: bosch wtc84100gb/04 no heat
replaced the ntc, toc was fine , i put some damp clothes in and went off for 20 mins came back and heating fine , i removed the condensor and a lot of water had gathered on the flat just in front of the condensor , i checked it and a lot of the passageways are closed with lint , this is a tricky little condensor plastic wave like fins tried to wash it out with a hose no joy , looks like im gonna have to show this one the compressor !!
Re: Samsung rsa1 WTMH LC ER. on display
Bump sorry made an error on the model no. its RSA 1 WTMH also when i press power freeze and power cool buttons together i get the multi segment error code but its also a new one on me it apppears in the freezer temp section and its l/h side next to the minus led the left top segment illuminated and the r/h side the middle segment illuminated , i get the l /h side one from the diagnostic manual is to do with the defrost sensor , but i cant see an error for the r/h side
