Forum Replies Created
-
Posts
-
Re: hotppoint wd 541/g stopped befrore spin cycle
hi again , i took the connector blocks off the main board and plugged them back in again , the machine started the cycle and went into spin ok , the machine was around 5 years old so i told the customer it was probably the main board 120 quid or so to buy a new one , so they said they would ring hotpoint and see if they could get the call out covered by warranty , sure enough the hotpoint van was outside the door next day , dunno what it cost but im sure it was at least 120 quid !!
Re: hotppoint wd 541/g stopped befrore spin cycle
thanks for that , will check it out and get back to you ,
Re: hotppoint wd 541/g stopped befrore spin cycle
cheers sorry model no is wf 541/g ser no. 707020360, left hand lights are from top no. 1 thanks again
Re: zanussi zwf 1231 e 30 error
update on problem no more e 30 new code is e21 the washer stops cycle at 21 mins will not continue will not drain , have to empty by hand
Re: hotpoint rfa 70 not freezing
ok that sounds expensive , a new fridge can be got for 350 euro thanks
Re: electrolux esl 6114 pnc 911841111 water trouble
ok managed to get this washer going the little 10 mm plastic tubing from the bottom of the iwms was hanging off , running fine for about 6 or 7 weeks and then stopped again same problem water not getting into the wash compartment
Re: tricity bendix biw 1000w not starting
that did the trick penguin 5.5 mm socket and new brushes cheers
Re: zanussi zwf 10020 w door light on
i take it its the tube that runs from under the tub up to a blue round switch under the top cover rear right hand side 8mm diameter with 2 pieces of sponge around it for protection , when i blew into it i could feel and hear water gurgling at the other end , i forgot my multimeter so i just connected it back up , i dont have an electrical schematic do you know which wires bridge out the switch for operation ? cheers kuango
Re: zanussi zwf 10020 w door light on
ok fitted new door intelock , and door locks now so thats good ,m/c was stopped mid cycle so is full of water switched to drain and pressed start .. nothing 10 mins nothing , bailed out water with jug as much as i could and restarted on drain cycle still nothing , opened filter and drained rest of water , restarted but i forgot it was on drain cycle and guess what … it started to drain ???? i let it finish and started a wash cycle, after 15 mins i stopped it and turned the switch to drain .. once again nothing so i repeated the above process once again ,any clues ????
Re: zanussi zwf 10020 w door light on
cheers phidom, i was looking at other similar posts which were pointing in the direction of motor brushes , so i wasnt sure 26.50 for an interlock here but im sure brushes are not too dear also thanks again
Re: servis m 3015 a module blown
couldnt find anything wrong with motor or pump , she decided to splash out on a new machine thanks phidom
