[slyp98]

Re: neff c7660N1GB/04 leaking water

anyone ever heard of these machines

[slyp98]

Re: de deitrich dvh610ju1 error D13

slyp98 wrote:hi all , hope everyone had a good weekend i know i did at the wsbk in donnington pk. anywho i was at this and its an over heat error , so i take it the thermistor is at fault , no? checked all the connections and the element the thermistor should be 44k ohms @ 25 degrees c , but im getting 76k ohms the water its in is more like 15 degrees

[slyp98]

Re: De Dietrich DVH640JU1 DISHWASHER

Hi johnnyboy , did you get this sorted , i have had a few run ins with these no heat and the heater ok usually the thermistor fault

[slyp98]

Re: Whirlpool ADG7550 8542 755 15820 beeping

just found the service manual online for anyone wants it pm me , looks like my prob is F1 error ntc failure ,

[slyp98]

Re: indesit WIDXL 126 uk leds flasing

For me anyway a lot stems from the tech friendly diagnostics not. and the fact they all need a new board to be post programmed wtf is that all about, give technicians a break , not too bad if you can manage to make em throw up a fault code but that varies from machine to machine

[slyp98]

Re: indesit WIDXL 126 uk leds flasing

I know ive lost faith in indesit products though

[slyp98]

Re: bush washing machines

cheers sce , i had a look at 2 so far ,one just sits with what look like board probs , start light flashing , thought door interlock, and checked motor and hello pat tester . the board is actually ok quality , the 2nd one, drum pulley bent ? it was loose on the shaft i just tightened it up but keeps spittin off the belt ,

[slyp98]

Re: servis wash m/c flasing leds

ok all sorted guys fill valve was the culprit

[slyp98]

Re: servis wash m/c flasing leds

I was onto her again she sayes it takes in water then stops after 20 sec a little while later spin and wash leds flash looks like press sw ar fill valve , i will call in the morn up to me eyes at the mo

[slyp98]

Re: bush washing machines

Cheers SCE. I might tell him ill look at 1 to see what gives

[slyp98]

Re: bush washing machines

Thanks guys, i was thinking as much but i said I’ll ask the expert’s

[slyp98]

Re: liebherr IGN 2566 temp too high

Yeah fan running and ice visible on back panel , serv no 9981212-05

[slyp98]

Re: zanussi zdf 2020 error code

Pcb edge connector block disconnected from the board reconnected all ok

[slyp98]

Re: bosch SGI45E16UK/10 no heat

they don’t look burnt Martin , but im gonna remove and check relay

[slyp98]

Re: hotpoint bhwd 129 wont spin

no 220v at the motor , press sw checks ok wiring ok to the board drain pump kicks in for 3seconds and then nowt, no lights, no error code looks like fried board i don’t see anything obvious but its smelling burnt

[Author]

Posts