Forum Replies Created
-
Posts
-
Re: hotpoint bhwd 129 wont spin
No lads its in my sisters house 100 miles away i got her to do a quick check over the phone in not drivin up to find the shaggin belt is off, in lookin for an idea of what i need to bring maybe a pressure sw or a solenoid ya know the parts someone has used to repair this kind of problem b4 but it looks like nobody has come across one of these
Re: hotpoint bhwd 129 wont spin
Nothing didn’t have time looking for any general faults , is it usual hotpoint board fault?
Re: Liebherr fridge not cold enough
its at 6 degrees , water running down the back panel , I turned it up last time I was there but it didn’t make any difference, I turned on the circ fan and its freezing the droplets at the back panel the stat is turned 2/3rd of the way round , so it should be very cold
Re: tricity bendix wdr 1040 washer dryer slow and short spi
still having trouble with this problem on a different machine same model,I removed the motor and used a compressor to blow out all the carbon dust still no change , anyone ?
Re: bosch WAE24469gb short spin
customer still complaining of spin problems , none as far as I can tell any ideas , brushes fine
Re: bosch WAE24469gb short spin
Customer complaining of no spin i couldn’t wait for a full cycle so i just thought put it on a spin cycle 12 mins , just figured it wasn’t working right when digi display jumped from 8 to 3 mins
Re: BOSCH DRYER WTB76556GB/05
i had one of these last year E18 error , no heat all tocs fine , new board was needed , or if you can swap the new relays in , i dont have any tech info though
Re: hotpoint bd 32p top oven lukewarm
i could barely get access to the bloody thing 2 foot of mains cable just about came out to the edge of the cabinets , couldnt get at the back panel screws , need to have a helper when i go back will give it the once over next week thanks Graham
Re: hotpoint bd 32p top oven lukewarm
cheers jim, yeah fine im just miffed by the stat neon going out and no voltage at the stat tags , i just need to trace the power path until i find the place it stops , i have a wiring diagram so thats a start cheers
