Forum Replies Created
-
Posts
-
Re: de deitrich dvh610JUI water leaking into base
ive been to another one of these , same fault replaced door seal at bottom and surround , still letting lots of water into the gutter at the bottom of door and onto the floor! this is obviously design fault someone must have come across this b4 no?
Re: de deitrich dvh610JUI water leaking into base
It hasn’t been used for 2 weeks no detergent used either there isa constant drip from that tube
Re: neff h5430nogb/02 microwave tripping rcd
Is the inverter available separately do you think i am quoted 175 for the mag and 198 for the inverter board all plus vat that’s close to a new microwave
Re: neff h5430nogb/02 microwave tripping rcd
very sorry Dave wrong way around , insulation comes up as over range , no reading on display and continuity is 0.09 ohms 200 ohms scale
Re: neff h5430nogb/02 microwave tripping rcd
Ok meggered the mag, .09 ohms on 200M ohms scale insulation zero ohms resistance between poles continuity looks like prob is the hv transformer or the inverter on the pcb what do you think Dave
Re: neff h5430nogb/02 microwave tripping rcd
No my megger is kaput , i need to buy another maybe i can bring it to an electrician friend of mine tomorrow cheers Dave
Re: neff h5430nogb/02 microwave tripping rcd
Hi again it will not run at all with the inverter connected and will run for 5 seconds with it unplugged it had the magnetron connected both times i can restart it also but i cant stop it then it just runs again for approx 25 seconds but i can keep restarting it
Re: neff h5430nogb/02 microwave tripping rcd
Hi Dave , the neff site wont recognise the number im putting in i went onto connect site ,anyway is that part no 482202 the pcb with the invertor on it ? it will run with the invertor disconnected for a short time and with both disconnected for a long time , does the fact the bulb goes out have any bearing , thanks Kieran
Re: belling xou 90mf mk 2 cooling fan prob
Yeah i understand you i still think there is another prob though i could spin it faster by blowing through it
Re: MIELE DA 269-4 pcb for sale
slyp98 wrote:Hi guys ,i am stuck with this after wrong board was sent special order part , its the main pcb power board
sorry guys wrong model no in original post above
