[snig]

Re: configuring zanussi zwf1427 module

Thanks for that. As you say it looks like the board comes configured,
unlike the earlier versions.

[snig]

Re: Diplomat ADP 8242 (D/W)

If its the model i am thinking of fault code says no drain in time allowed. Check page 50 of white good fault code if you have it.

[snig]

Re: AEG 5410 oven no heat

sorry, meant to leave that, 944181074 -107 / 713313

[snig]

Re: Hoover tumble dryer board configuration?

I was afraid of that. This was the second board, can’t afford to lose any more money on this job !

[snig]

Re: Hoover tumble dryer board configuration?

Sorry if i’ve confused the issue. Original fault; machine starts and turns but no heat. Traced to no supply from pcb. Fitted new board, NOW won’t do anything except sequence thru various led displays each time you press start button ?( not related to programme so assuming conf. code or similar ). Refit original board, machine reverts to original fault.

[snig]

Re: Hoover tumble dryer board configuration?

thanks to peagasus for your reply. Called today with another board, still no joy. Lights come on and cycle thru a sequence when you push start button but nothing else. Refit original board and everything works ( except heater, original fault) Seems quite obvious this board needs configuring but no info or way to do it ! Very annoying if these boards are sold as configured !. Anyone else have any ideas ?

[snig]

Re: Hoover tumble dryer board configuration?

If it came unprogrammed, how did you get over it. Did you send it back or can it be programmed on site ?

Paul

[snig]

Re: Hoover tumble dryer board configuration?

Yeah, thats what i fitted. Must be a faulty board then ?

[snig]

Re: Candy CIC324 AK fridge too cold

Been back with thermistor and info only to find thermistor is not where indicated. measured very carefully but just not there! very annoying as still the same amount of work involved. Be warned!!!!!

[snig]

Re: akz145 oven

called back today and cut resistors but still not working. Just reads STOP ?Only option seems to be a new board ?

[snig]

Re: akz145 oven

Thanks for the info. I’ll give it a go

Paul

[snig]

Re: akz145 oven

Hi, i’ve the same fault on the same model oven. Following a power cut display reads stop and will not move on to set time or do anything!. Would luv to know how you resolved it , and why it happens ? Paul

[snig]

Re: Candy CIC324 AK fridge too cold

Thanks for that. Very informative. At least it can be done and were not righting off the unit for the sake of an ntc.

[snig]

Re: Candy CIC324 AK fridge too cold

A HA. Just realised my Email address was not up to date. Be very grateful if you could try again now i’ve amended it.

[snig]

Re: Candy CIC324 AK fridge too cold

Hi Chris, thanks for trying but i haven’t received anything? should i be looking in my Email or messages. ( although i have checked both ).

[Author]

Posts