Forum Replies Created
-
Posts
-
Yes, thats exactly it. Reverts to default. I will try a new selector switch.
How do you access the test programme, does it come up after switching off then on ?? and whats a test finger ??Doesnt overheat. After a couple of minutes temp. will alter itself, normally down.
Pretty sure i would of checked elements but can’t actually remember. I may go back and check again when hot !!I realise this is an old thread but have a similar problem on a Neff oven. Did you find the cause. Customer had bought a new thermister which i fitted for her but still intermittantly resets to 160 deg.
I havent checked that. Sounds like a good wash action but will check properly on next visit.
My thinking now is possibly reconnected the wires to the diverter wrong ( they are all white so easily done ), as if no signal from microswitch then no heat ??? Hoping if thats the case i havent damaged the module. Luckily customer is being very good about iti found a second ntc at the back of the tub below the pulley which was faulty. replaced and been ok since
Thanks for that. Seems very similar too older machine diagnostics. I’ll call back and check last fault codes
Yeah, that looks like the bit. Talk about overly complicating things. This ones the same part number but ends with D instead of B
getting a reading of about 45K when testing from the module so assuming thats ok, guess i must be looking at a module fault ??
