[stamm]

Re: Leisure Cuisine Master RCM10 Regulator

It seems that the online store do not stock the part so does anyone have any ideas where I can get one from?

Thanks
Roy

[stamm]

Re: Hoover HNL7146 Noisey spin

Thanks Spanish
I laid the machine on its back & removed the pump hose from the drum & I imediately saw the usual bra wire which must have been lieing tight to the outer drum. All I can suggest is that it move until more weight in the drum hence more movement.
I then tried a couple of towels on spin cycle & even on full speed no noise. So hopefully cured fingers crossed.
Thanks to all for your help.
Roy

[stamm]

Re: Hoover HNL7146 Noisey spin

How can I tell if its the drum support spigot are there any signs such as the inner drum not central? If its coins in between how can I get them out?
Thanks

[stamm]

Re: Hoover HNL7146 Noisey spin

Hi Firestarter
Thanks for the reply. By scoring do you mean on the front edge possibly due to the inner drum falling or do you mean from coins etc between the drumd? If its a plastic outer drum how come the noise is metal on metal with just say coins trapped? Also how can I get them out?
If the inner has dropped how can I tell & does this mean the bearings again?
Thanks
Roy

[stamm]

Re: Candy GOV58F lights flash

Many thanks for the reply helo_75 its much appreciated. I think we will live with it for now as we can imagine the cost of callout etc.

Stamm

[stamm]

Re: Candy GOV58F lights flash

Hi Helo
What do you mean ambient temp lockout? Why is it intermittent & how do you reprogramme?

[stamm]

Re: Candy GOV58F lights flash

Yes it starts off & keeps going after 3 or 4 goes but the next time it may run 1st time.
No its in a utility room not in a garage.
The machine is just over a year old.

[stamm]

Re: Hotpoint WMA33 will not start

Hi Iadom
Yes a butt connector RS Stock No. 613-9794 Red. if I can get the motor out to check the brushes I may be able to see the other end in the loom.

Roy

[stamm]

Re: Hotpoint WMA33 will not start

Hi iadom
Many thanks for the details on motor removal? I understand rule 8 & I am just after a clue as to where to look for the other end of the wire or if it is actually spare.

Regards
Roy

[stamm]

Re: Hotpoint WMA33 will not start

Thanks for that info. Yes the violet wire is attached at element end but where does it go to please?
Does the motor remove from the base as only a small rear panel?

[stamm]

Re: Belling IDW603 dishwasher

Hi Penguin
Many thanks for te reply. Possibly better leave the repair for now until funds are available then or get an engineer out to make sure it is that before proceeding.
Thanks again for teh info .

Stamm

[stamm]

Re: Belling IDW603 dishwasher

Hi guys
Does nobody have any ideas on what could be wrong with this dishwasher?
Its a pain in the neck washing dishes by hand .

Thanks
Roy

[stamm]

Re: Zanussi rotary programme selector

Thanks Penguin. I take it you have to take off the intergrated panel or is it all done from the stainless side or does the front plastic panel come off? Do you have any instructions for taking the door apart.
Thanks
Roy

[Author]

Posts