SteveATY

Forum Replies Created

Viewing 15 posts - 16 through 30 (of 78 total)
1 2 3 4 5 6
  • Author
    Posts
  • December 21, 2018 at 3:27 pm in reply to: Zanussi DW not heating #459638
    SteveATY
    Participant

    Check the heater relay on the main PCB. Looking for either a dry joint (which sometimes can be difficult to see) or relay failure which normally shows heat damage if it’s a white relay.

    April 30, 2018 at 7:37 am in reply to: Rangemaster Elise 100 Induction. #455615
    SteveATY
    Participant

    Re: Rangemaster Elise 100 Induction.

    Hi Guys,

    Thanks for the input.

    The client had originally had someone recommended by Rangemaster to look at the appliance and apparently they “glued” the top back down.

    I think that the only way forward is to go and see the unit (assuming the clients wishes to pay labour etc.)

    Thanks again,
    Steve S.

    January 12, 2017 at 7:50 am in reply to: AEG Dishwasher i20 – Technical Manual Request. #444396
    SteveATY
    Participant

    Re: AEG Dishwasher i20 – Technical Manual Request.

    Thank you Dave – Most useful. Fingers crossed!

    Have you done one of these yourself? Any tips?

    December 30, 2016 at 3:27 pm in reply to: AEG F55002VI0P Dishwasher i20 #442200
    SteveATY
    Participant

    Re: AEG F55002VI0P Dishwasher i20

    Have similar – did you manage to fix this one?


    Steve.

    December 30, 2016 at 3:22 pm in reply to: aeg f88060vi0p dishwasher #440287
    SteveATY
    Participant

    Re: aeg f88060vi0p dishwasher

    Did you get anywhere with this one? I have similar issue on a clients machine.

    Wondering if this is one with a pressure switch upgrade kit.


    Steve.

    December 12, 2016 at 12:49 pm in reply to: Bosch Washer Dryer WVD24520GB/03 #443477
    SteveATY
    Participant

    Re: Bosch Washer Dryer WVD24520GB/03

    For the few minutes that the dryer does run, it does start to get warm.

    I have it booked in for tomorrow afternoon. Should be fun!


    Steve.

    December 9, 2016 at 6:40 pm in reply to: Bosch Washer Dryer WVD24520GB/03 #443475
    SteveATY
    Participant

    Re: Bosch Washer Dryer WVD24520GB/03

    Thanks for the replies guys.

    I’m going to get it booked in again for next week and give it a good going over.

    I suspect a blockage of some sort. Someone else mentioned a similar problem on another website.


    Have a great weekend,
    Steve.

    December 9, 2016 at 8:59 am in reply to: Bosch Washer Dryer WVD24520GB/03 #443472
    SteveATY
    Participant

    Re: Bosch Washer Dryer WVD24520GB/03

    Tested inlet valve when we first had the F18 fault and it was fine.

    June 16, 2016 at 3:55 pm in reply to: aeg 911436014/08 d/w #437224
    SteveATY
    Participant

    Re: aeg 911436014/08 d/w

    But i20 is a drain pump time out fault?

    June 16, 2016 at 10:38 am in reply to: aeg 911436014/08 d/w #437222
    SteveATY
    Participant

    Re: aeg 911436014/08 d/w

    A customer of mine is having the same issue on an AEG F88002W0P Dishwasher.

    Although the machine empties without any problems the i20 fault still occurs and the cycle stops.

    Did this problem get resolved?

    s4stevie@hotmail.com


    Cheers,
    Steve.

    August 6, 2015 at 9:11 pm in reply to: Hotpoint HV7L130 washing machine won’t fill / pump repair. #429470
    SteveATY
    Participant

    Re: Hotpoint HV7L130 washing machine won’t fill / pump repai

    Unfortunately this method does not work when the machine has been switched off when the water was manually drained.

    Any further ideas would be useful.

    May 1, 2014 at 7:43 am in reply to: Bosch SMS69L02GB/02 Dishwasher – Heating problems. #413106
    SteveATY
    Participant

    Re: Bosch SMS69L02GB/02 Dishwasher – Heating problems.

    So what is the technique? Work from the front reaching inside the base inclosure?

    November 19, 2013 at 12:22 pm in reply to: AEG 59800 Tumble Dryer (Heat Pump Type) – Not drying #404750
    SteveATY
    Participant

    Re: AEG 59800 Tumble Dryer (Heat Pump Type) – Not drying

    Thanks Colin.

    November 19, 2013 at 8:53 am in reply to: AEG 59800 Tumble Dryer (Heat Pump Type) – Not drying #404748
    SteveATY
    Participant

    Re: AEG 59800 Tumble Dryer (Heat Pump Type) – Not drying

    Thanks Colin.

    The circulation fan is running. The one that is mounted in the rear cowling.

    s4stevie@hotmail.com


    Thanks again.

    February 4, 2013 at 10:51 am in reply to: Diplomat Whirlpool Flow Meter F7 Error #387679
    SteveATY
    Participant

    Re: Diplomat Whirlpool Flow Meter F7 Error

    Interesting find.

    I have an F7 to call on at lunchtime. Will bare in mind.


    Cheers,
    Steve.

  • Author
    Posts
Viewing 15 posts - 16 through 30 (of 78 total)
1 2 3 4 5 6