Forum Replies Created
-
Posts
-
Re: Maytag American F/f
r600a wrote:Hi
If I remember right this has 2 glass defrost heaters,one in the middle and one at the bottom in series with each other,there are 2 different sizes,whats the internal width of your freezer.
Bryan
Internal width approx 15inches, heaters has one large one that sits just above drip tray and thin one wrapped around evaporator like samsung. It looks like they are in series could only trace one pair of cables.
Are they easy to change
Re: Hotpoint wma30
Cheers
After all went out found customer is in the middle of a kitchen refurb, drain hose about 6 inches off the ground runs out of cat flap round a corner straight into waste pipe.
Dont know how it worked ok for this long.Steven
Re: Servis W/m
robinsonrobbo wrote:check earth leakage on heater just pull off the wires and try it had this before. also check belt tension should be bow string tight.
Yep have checked for open circuit and earth fault.
I know in the past repaired boards dont always work, have replaced them with new, then it seems to be ok, may have to do that with this one.
Trying to keep the cost down by repairing pcbs sometimes costs you more in the long run.Re: Bosch d/w
My first port of call was to the mains filter, then heater etc, when they tested out ok, started to disconnect everything one by one until I found that the board was the only thing still connected. 😕
Re: Servis W/m
robbra wrote:Definitely board. Common fault. Haven’t changed a Servis timer since 1998 when they went to dmpa modules.
Rob
Sent Board to QER for repair, had it back still same , so ordered another repaired one just to confirm, still same thing.Re: September 2007 Meeting
Hi Ken
Havent been there before so can I have details on the The Millers?
Does it start Thursday or is it the Friday at 10amCheers
Steven
Re: LGWD1431RD
cheers guys
Had disconnected door lock still blew, have ordered pcb so will know later if ok.
Thanks
Steven
Re: House of Horrors
How do we now repair built in or fixed appliances, have we got to go on the course and be part p registered.
By ‘fixed’ does this mean that anything wired direct to spur outlet is classed as fixed how do we know what we can or cannot work on it 😕 As we know most of our jobs these days involves this type of installation.
StevenRe: Diplomat ADP8332
Thank you Brian
That wood explain why when it was pulled out it worked once then pushed back in place it failed again.
Inlet valve & hose all ok.Cheers will check it out
Steven
Re: AEG FAV86070 D/W
Had this model on test for a while now and at long last found out where it is leaking from.
On intensive wash about 55 minutes into program it leaks out passed the sump gasket, as though too much pressure is building up inside.
Has any one had or know why this would do it at this point in the program.Cheers
Steven
