Forum Replies Created
-
Posts
-
Re: diplomat apm8703 washer dryer (servis) no spin
yes, thanks for that aqualectric, I have checked that with a mega, thanks anyway.
Re: diplomat apm8703 washer dryer (servis) no spin
Thanks Chris, I just wanted a seccond oppinion really. cheers.
Re: Indesit WIL163UK Strange fault???
That is a good point helo_75. never even thought of that.
I think i need to go back again and have another look 😳Re: Indesit WIL163UK Strange fault???
Hello again, I kina ruled motor brushes out as it did a spin lovely and it sounded in good fettle. Also, its only 14 months old and its an elderly lady who lives on her own.
In relation to the water valve, its a cold fill only, but thanks anyway.
Rob.Re: Are you quiet at the moment or is it me?
I usualy charge £25 inc vat plus parts for freestanding an £35 inc vat plus parts for built in but it can vary, ie. bearing jobs or Neff built in dishwasher heater unit/motor etc.
Robert.
Re: Are you quiet at the moment or is it me?
Send some over to me please aqualectric… 😉 I too love intergrated machines, you can charge more for repairing built in too! I advertise myself as a built in specialist, I have repaired built in stuff for about 15 years or so now, and like you say, a repair is usualy always cheeper than a replacement. Even bearing jobs have a chance!
Robert.
Re: Homark Grill element required.
Hi Chris, thanks for that. I have just put that part number into connect distribution and it doesn’t recognise it. any reccomendations as to who could supply one?
Thanks,
Rob.Re: aeg dishwasher leak into base
Up to press I have done two of these aeg dishwashers which spill out of the clear breather tube on the regen unit. I was stumped and reluctant to order up a new plastic regen chamber, but when I did it solved the problem on both occasions. I tried everything, pressure switch, sump hose to regen pipe was clear. I was a nice easy job to do if I remember, but you will need to wear your goggles and swimming trunks 😉
Regards,
Robert.Re: Zanussi FLE1216W stops after 8 secconds
Ermmm I didnt realise I had… Was a mistake. It was ment for the Trade Technical Enquiries forum.
Don’t know how that happend.
regards
Robert.Re: Hotpoint DT77X Built in Double Oven – No Heat
Thank you very much for that kiddo66 & aqualectric.
I went back to it today, as you said, blown link in the switch first contacts on the r/h side. Was very hard to spot too! I had to take the switch off and turn it upside down before I could see it. I cut into the wiring and linked it togeather with a butt connector, works a treat!
Thanks again!
Regards,
Rob.Re: Hotpoint DT77X Built in Double Oven – No Heat
I did have a good look at the selector switch, I even scratched the points with my neon terminal driver to freshen them up, but to no avail. The selector switch was my first thought really along with the stat of course.
Just wish I had one in my pocket though so I could rule it out…Re: Hotpoint DT77X Built in Double Oven – No Heat
Forgot to mention, I also checked the microswitch behind the left side panel, and that is ok..
Re: Hotpoint CTD00p water light on all the time.
Had a bit of a play. I cleaned out the float chamber on it and the float. The water container light is lit but only dim. Heat doesnt feel as good as it should either, possibly running on low heat…?
