Forum Replies Created
-
Posts
-
Re: Askoll take over Plaset?
not sure about takeover, but ive interchanged them loads of times, never had any bother tbh
Re: Trading slogans?
“youve tried the rest now try the best” 😳
“no spin no drain i know its a pain, give us a call we’ll get it going again” 😳
Re: Indesit IDL 505 dishwasher
is water in base cust will be looking in the sump 😉
usually just over foaming due to tablets, can be leaking motor etc tho
Re: Zan ZWF14070W1
a dodgy pressure switch 1325162038 is likely on these, ive had a few a little tap gets them going again, failing that a new switch usually sorts it.
check the fault code stored in memory it could be e38 or something, i had 1 the other day pump running nothing else checked switch still no joy, i then looked at the code, reset it and it worked again, touch wood not been back since.
Re: beko wm765
nothing listed for that code here is what i have
H1 : NTC OPEN CIRCUIT OR SHORT CIRCUIT ( 10000 )
H2 : HEATER OPEN CIRCUIT ( 01000 )
H3 : HEATER ALWAYS ON ( 11000 )
H4 : VALVE TRIAC SHORT CIRCUIT ( 00100 )
H5 : PUMP OPEN CIRCUIT ( 10100 )
H6 : MOTOR TRIAC SHORT CIRCUIT ( 01100 )
H7 : PRESSURE SENSOR FAILURE ( 11100 )
H11 : MOTOR / TACHO OPEN CIRCUIT ( 00110 )Re: Hotpoint TDC32 Stops dead
was just about to post about wall socket, i had the very same fault recently, i tried on a different socket and it was fine, cust got a new socket fitted and ive never been back!!
Re: diplomat aba 6541
fan jammed with ice or faulty, take of panel at rear of freezer and have a look, probs just needs a defrost.
Re: clarify wd12 indesit w dryer
f13 on these is a dryer fault, check ntc, heater or blcoked condenser.
