[A1engineer]

Re: Looking for employment in the Motherwell area

only really 2 companys in your area who might be suitable you could stick a cv into them

scott pollock
a1 repairs
143 merry street
motherwell
ml1 1jp

or
walter russell
RDA
13 Bowling Green St
Bellshill,
ML4 1AU

hope you get something sorted, i just started out myself 6 months ago, so not ready to start hiring, but you never know what future holds 😉

[A1engineer]

Re: Flybe “airside” installs

i could cover Glasgow, Edinburgh and Prestwick 😉

[A1engineer]

Re: 0800 Repair

saw a big screwdriver drive past me today in Hamilton, yellow vans with 0800 REPAIR all over them..

[A1engineer]

Re: Beko WM5120W Motor part no.

2818570100

not too bad usually depends how often it is used etc…

[A1engineer]

Re: Hoover Washing Machine – No Pump But no Fault codes

it will be the pcb, you could have a look for a blown triac on the board to be certain but id be fairly confident, hoovers dont usually give fault codes when the boards at fault.

[A1engineer]

Re: Bosch WVT1260 steaming

yip usually is the condensing valve its part of either a double or triple cold valve.

[A1engineer]

Re: Hotpoint WF840

you will most likely find its a board fault, motors dont usually give the juddering symptom unless the brushes are struggling to make contact.

i always keep a good motor in the van to stick in only takes a second to plug in and is easier to check than the board!!

[A1engineer]

Re: ctd80

F07 Lower Element Failure – Verify wiring to heater.

HTH.

KEV.

[A1engineer]

Re: Diplomat ADP3702 cooling fan

the pcbs are prone to failure…

[A1engineer]

Re: vtd00p wiring diagram

check your email 😉

[A1engineer]

Re: beko dishwasher

usually pcb tbh, im sure they end up stuck on the prewash cycle or something, changing pcb has cured a fair few for me, be careful tho there can be a few different part numbers for the pcbs.

[A1engineer]

Just home really enjoyed couple of days, thanks to all who made this newbie very welcome. Met some really good people and hope to meet again soon.

Only downside was the ideot on the m6 who decided to ram me on the way home and probably write off my car 🙁

[A1engineer]

Re: whirlpool dryer drum not turning

does it turn itself once you give it a push, then if it has a cap its cap every time.

[A1engineer]

Re: September meeting @ coventry hilton hotel

jackster wrote:I live about 15miles away and would really like to come, do I just turn up? Sorry about my ignorance but I have only ever been up for a brew with J Mac (ex-boss) in the past! Need to put a few faces to names and as I have only just started out on my own it could be invaluable for me . Just aI bit conscious of the fact I dont know anyone!

I’m IN same boat I’ve been assured they don t bite tho

[A1engineer]

kwatt wrote:Yup, and it’s working. 😉

K.

safe some for the workers…..

[Author]

Posts