Forum Replies Created
-
Posts
-
Re: Miele pw6065 overfilling
Hi
Normally it’s the plastic pipe which is at the bottom of the tub under the door seal.Normally full of scum and stopping the pressure switch from working correctly.
The front of the appliance will need to be opened to access.Bryan
Re: Samsung Fridge Freezer : SR-L3928B Freezer Died
Hi
This’ll be a R600a compressor and will need a Aspera 1/5hp compressor will fit or a genuine samsung compressor at approx £70 plus postage plus vat just for the part. we have in stock.
Bryan
Re: Payments – First4Service
They have just sent an email out regarding due to computer issues they have not got paid by there suppliers which means no payments this week.
But that’s not our fault an they should factor that into the working capital.. I’m sure that the wages won’t get paid late.
Bryan
Re: Samsung wf1124xac Eco bubble
Hi
It makes no difference on which wire goes to which of the 2 terminals.
The biggest problem we had was the eco ball getting stuck and not allowing the water to drain away.
Bryan
Re: Homark 0-700401/1 oven Minute minder
Hi
So you need a minute minder for a oven with the contacts on the back ? I should have one sitting about.May not be the genuine part but it’ll do the job.
Bryan
Re: Homark 0-700401/1 oven Minute minder
Hi
Does the customer actually use the time for timing ?
If not then by pass the minute minder
Bryan
Re: Hoover dyn9164 e01 fault
Hi
The fault clears itself when switched on and senses door closed. It will hold the fault on the core board until cleared using a mem reader. If you have one.We have then as we do a lot of HVR work under warranty and its easier and faster to get a clear idea of the actual faults.
Bryan
Re: Hoover dyn9164 e01 fault
Interesting. So to prove the door is required presumably all you need do is trip the interlock with the door open, and the code clears?
No. We change both the door and interlock as we have changed the interlock previously and had to order the door so we kill it on first visit.
Bryan
Re: Hoover dyn9164 e01 fault
Hi Deltra
Then the door will be required as a complete unit.
This has cured the ones we’ve had under warranty and out of warranty. Don’t ask as we cannot work out why.
Bryan
Re: Another joke.
The latest machines…
http://66.media.tumblr.com/f3c0c928c79e37f981db86d62154d0ec/tumblr_o13vkbyeqB1s02vreo1_500.gif
Bryan
Re: vat
Hi
The majority of service providers would prefer you to be vat registered as it makes their life easier and they can claim back the vat element of the claim. where your not vat registered they have to process in a different way.
Bryan
Re: Samsung SR-S2028CVW
Hi
Please use the search function and read the posts..ALL the information is there.
Bryan
Re: cooker hood extraction
Hi
No 2 into 1 won’t go. they will fight each other if they are both on at the same time and cross contaminate.
You will need to use a minimum of 5″ ducting also. distance requirements :
each bend equals 0.5 mtr and exit vent is classed as a bend. Normal hoods are rated for maximum run of 3-4mtrs total.
Bryan
