Forum Replies Created
-
Posts
-
Re: miele dryer t8302 starts then stops after 1 min
If I remember correctly there are a set of brushes that run on the top of the drums ass and they wear down and give this error.
Bryan
Re: any advice on attracting new work?
Hi
Yes.. Get the full skill set including gas safe and refrigeration. Be prepared to go outside your comfort work area.
Bryan
Re: washed PVC apron in wash !!
thanks, no luckily it didn’t but been doing maintenance washes all day and it really is taking an age to get rid of the smell, BIT better now. Think it probably stuck to the drum or something..plus all my washed clothes stank of it !! 😡
Re: Westinghouse Fridge/Freezer
Hi
A universal handle is really the only ones that you will get to fit on a appliance this age.
https://shop.ukwhitegoods.co.uk/un53119-universal-fridge-freezer-door-handle
This will do the same job,You may have to make another screw hole but that will not affect the appliance what so ever.
Bryan
Re: indesit freestanding gas cooker thermocouple ?
Hi
Pull he knobs off and then push them back on gently and retry it..Most people use too much force when they turn the gas taps causing them to go past a stop point within the knob.
Bryan
Re: Stailess Steel Paint for Plastic Oven Handles
Hot oven door handles? Something’s wrong if the ruddy handles get hot!
Handles under the EUBS standards are allowed to reach nearly 100oc as are knobs
Bryan
Re: Stailess Steel Paint for Plastic Oven Handles
Hi
Exhaust paint would probably do a better job as its heat proof to a certain extent.
Bryan
Re: Maytag MSS20C1114 Ice Cube System
Hi
If you have ice forming on the base of the freezer section then it’s probably due to a blocked drain.
Bryan
Re: Cooker Hood ducting hose for gas hob
Hi
Nothing in the gas safe or BS standard but !! use rigid if you can as it’s quieter and cleaner and not a lot difference in cost. Must be 760mm from hob top though unless both the hob and hood manufacturer are the same and both manuals state the same. if different manufacturers then 760mm.
Min size for ducts now is 125mm and each bend equals between .5mtr & .75mtr the exit is classed as a bend.
so if the main length if duct is 4mtrs and it has 3 bends the total length would be approx 4.5 – 5.25mtrs if the hood manufacturer states max run of duct is 4mtrs then it could void the warranty.
Bryan
Re: Candy CNE 128 pgrogram selecor / timer
Hi Joe
The parts breakdown isn’t available on line but the part numbers are below as long as the production number is 31000151 (first 8 digits where your serial number is ) There is 2 models listed similar to the one you have given :
91201337 Motorized selector 30 settings
It’s showing as still available
Bryan
