Forum Replies Created
-
Posts
-
Re: Looking for opportunities in midlands
Hi Jackster
Have you tried to contact phill at MDM Appliances ?
Bryan
Re: Where can I find the thermostat in my frostfree frigidai
Hi
The part Number is 1112797 and yes it is behind the light housing. You just need to be forceful removing the plastic lens..There was some that had a small screw holding the lens in place.
As this is a frost free unit the common faults were that the duct from the freezer got blocked with frost from the freezer and this jammed the fan.
Try defrosting the unit by switching off for 24 hours with both doors open and then restart it.
The defrost timer is on the top under the lid
Bryan
Re: Are your nuts tight? A rusty tool?
This wouldn’t be allowed now due to the innuendo brigade
Bryan
Re: SAMSUNG – MARTIN DAWES
Hi Ally
I don’t seriously think that Martin Dawes would be big enough for the whole of the UK and which company would be stupid enough to do it ?.
They may wish to cover the northern areas but not southern. And personally I wouldn’t put myself into the position that Samsung will squeeze every drop of blood from you and then drop you like a stone.
Bryan
Re: GE – Water dispenser.
Hi
More likely that the water pipe in the door assembly has frozen. Turn the appliance off with the freezer door left open for 24 hours then try again. It’s a common problem with the GE fridge freezers.
Also check the connector block at the bottom of the freezer door behind the vent trim. this is normally also corroded. Butt connect the cables outwit the connection block.
Bryan
Re: ISE 1606 fault part 2
Where are all the ISE experts when you need them eh Jumpty?
If I remember correctly Martin.. Wasn’t it you who beta tested one of the ISE’s ?
And so many have given so many answers which are guess’s as we haven’t seen it or tested anything and can only assume that the testing is carried out correctly and the test program has been run correctly.
We aren’t all mind readers and all can’t teleport visions.
Bryan
Re: Whirlpool to do a recall on Hotpoint dryers
AUGUST for the mod!! I queried him but was assured it was August for his one.
Yes…But which year :rotfl: :rotfl: :rotfl:
Bryan
Re: ISE10 repeatedly failing thermistor
Hi
Send me a photo of where it is leaking from
Re: ISE10 repeatedly failing thermistor
Hi
Firstly
Follow the water stain from above as the water does not climb up the side of the outer tank. When the lid is off you will see white stains running down towards the sensor. When looking from the front of the machine look at the right hand side..Is there a white streak going down the side of the tank ? Follow that to the point where it starts.
Bryan
