Forum Replies Created
-
Posts
-
Re: Miele Dishwasher – Fully Integrated – inlet/drain light
The pressure reducing valve is fixed to the end of the water pipe, (the dishwasher end) we have about 1.2 bar of pressure to our combi boiler, so no pressure to reduce. The installation instructions say not to cut or damage the pipe, ie not to remove the box from the end of the pipe.
Re: FRIDGE SEAL – Where to buy replacement?
Hi Dave
I think I do need the seal as well as the magnetic seal doesn’t shut flush at all anyway.
Can you recommend??
Thanks
Vivienne
Re: Miele Dishwasher – Fully Integrated – inlet/drain light
It is a new install, i have checked the pipe, and the waste, i even removed the seal cap thing from the waste pipe, am i missing anything to do with the pressure reducing valve on the cold water pipe? Did I have to remove anything from the dishwasher itself?
Thanks so much, I checked and cleaned the filter which didn’t seem too bad to me but when I replaced it, it worked a treat. I realise that I hadn’t been cleaning the filter as much as I used to,it’s amazing that something so small can cause the machine to stop working, I will be cchecking and cleaning the filter much more often now. Thanks again.
Re: FRIDGE SEAL – Where to buy replacement?
Hi Dave
As requested, I hope the following numbers are useful:
Model # APM6325 SX (or it could be 5X)
Series # 20011009118
SchrieberThat’s all I could find!
I require a new magnetic door seal and also a door hinge. The fridge door opens from the right (so I need a top left hand corner hinge). It’s an integrated fridge, so the hinge is for the cupboard door.
Please advise how much it will cost and where to send payment to.
We can take this offline – e-mail me on vivienne.ly@three.co.uk and I will be happy to phone you wirth credit card details or post a cheque??Thanks and regards
Vivienne
Re: diplomat tumble dryer triping rcd
just found out a new integrated one, same model is 227 …….is it worth me pursuing fault on old one?
Re: diplomat tumble dryer triping rcd
plug always pulled!
no problem with heater element, but what does the mains spressor look like/located?
thanks, timRe: diplomat tumble dryer triping rcd
hi,
its apm8260 which is hygena, but branded as diplomat apm 8260. Its got to be at least 3-4 years old now, nearer the 4!. Only just started to do this and doesnt seem to be from cold. Dont know if its worth taking the motor to local shop to get it checked and coil if motor ok?
thanks, TimRe: Part P Or Not To Part P
well said Richard.
If ever there was a case of fueling a fire this is it.
It will put those who are disadvantaged because of MONEY, at even greater risk of the cowboys.
This will not stop their activities but increase their market.kevin
Re: Bosch dishwasher – no heat
Hi andrew,
As Sparky says the heater relay on these suffers from dry/burnt contact. Its an easy fix, usually without parts.
If you look in the directories section(on the left) and punch in your post code to see if we one of us is in your area.
Kevin.
Do it now in time for the xmas pots 😆
Re: AEG oko lavamat washer, error F9
This sorted me out too – Thanks!
I have an OKO-LAVAMAT 87620 and it was a C9 error. Set dial to off, held Start button in and turned dial to Gentle Rinse.
Re: Bosch dishwasher – no heat
Hi mine has done the same thing, it is the same model and age. How did you get it fixed and what was the problem ?
Thanks AndrewHoover Performa 1100 washing machine instruction manual
Can anyone help with how to get an instruction manual for this machine?
