alfie

Forum Replies Created

Viewing 15 posts - 16 through 30 (of 61 total)
  • Author
    Posts
  • in reply to: Bosch WVF2402GB/02 #340801
    alfie
    Participant

    Re: Bosch WVF2402GB/02

    Mmm nor me. ❗ A Bosch boffin required me thinks

    in reply to: whirlpool ADG1597W #340231
    alfie
    Participant

    Re: whirlpool ADG1597W

    I had one like this a while ago don’t no if it’s the same model but it might be worth looking at the heater circuit.
    Mine had a fault on the pcb in the door presumably the relay ❓
    Hope that helps

    in reply to: Bosch Dishwasher SGS46E26GB/01 #339434
    alfie
    Participant

    Re: Bosch Dishwasher SGS46E26GB/01

    It was indeed the impellor jug (424099)

    Great advise many thanks

    in reply to: Bosch pcb repair? #339468
    alfie
    Participant

    Re: Bosch pcb repair?

    While on the subject of pcb repair I’d like to take this opportunity to thank contributors to the sticky section.
    Before the Xmas break I did my first repair. Replacing a start button on a Bosch pcb.
    Very fiddly probably because my soldering iron was too big but rewarding and profitable none the less.
    Thanks again and best wishes for the new year

    in reply to: Bosch Dishwasher SGS46E26GB/01 #339432
    alfie
    Participant

    Re: Bosch Dishwasher SGS46E26GB/01

    PS

    Is this accessable behind left side panel ❓
    Ta ❗ ❗

    in reply to: Bosch Dishwasher SGS46E26GB/01 #339431
    alfie
    Participant

    Re: Bosch Dishwasher SGS46E26GB/01

    Thanks Martin, taking the lid off sounds like a three handed job 🙁
    I f there are no signs of muck is there a test I could do on the impellor jug or is it a case of changing it and see what happens ❓

    in reply to: zanussi zdt 40 dishwasher #338167
    alfie
    Participant

    Re: zanussi zdt 40 dishwasher

    Is this machine set on half load if the bottom spray arm is working ok ❓

    in reply to: Hoover experiance Req. #338182
    alfie
    Participant

    Re: Hoover experiance Req.

    Found out that these stats are 95c & 110c.

    On my next visit l will make sure that there are no restrictions

    Thanks for advice

    in reply to: Hotpoint Expert #337871
    alfie
    Participant

    Re: Hotpoint Expert

    Turned out to be a small button stuck in the end of washer outlet hose where it discharges into sink waste.
    V gratefull for all helpfull suggestions, thanks.

    in reply to: Hotpoint Expert #337870
    alfie
    Participant

    Re: Hotpoint Expert

    Thanks l’ll keep my fingers crossed that its a press swt.

    in reply to: Whirlpool AWZ510E Control intermittent #321830
    alfie
    Participant

    Re: Whirlpool AWZ510E Control intermittent

    I would check the pump, motor carbons then heater after that its head scratching time :rolls:

    in reply to: those nasty w/p pumps which leak from the rubber and… #319428
    alfie
    Participant

    Re: those nasty w/p pumps which leak from the rubber and…

    I recently had a Beko d/washer cycling pump leaking from the shaft to impelor . is this the type of repair you’re on about ❓

    in reply to: Beko Slimline D/W D2731 FW #335009
    alfie
    Participant

    Re: Beko Slimline D/W D2731 FW

    Yes thats ths stuff just could’nt remember the name too many grey cells now.

    No chance of a pump fix then ❓

    in reply to: Beko Slimline D/W D2731 FW #335007
    alfie
    Participant

    Re: Beko Slimline D/W D2731 FW

    The 78c overheat stat has tripped so the other 2 stats are probably u/s also.

    Wash motor is working but the pump seal thats attatched to motor is leaking. This could have caused low water level during wash cycle and fryed the stats.

    Can you get just a pump without buying complete unit ❓

    Or is there a way of repairing a sealed pump ❓

    Clutching at straws for a low budget household. ❗

    Providing this is a viable job remind me what that white paste is called between stats and tub.

    Thanks

    in reply to: CANDY CDV 262 T/D #336820
    alfie
    Participant

    Re: CANDY CDV 262 T/D

    I’m sure it will

    🙂

    Thanks

Viewing 15 posts - 16 through 30 (of 61 total)