[alro]

Re: ht BWD129 BLOWN PCB

thanks Jim
this should resovle my problem as i have about 25 to look after in a couple of letting agencys work thanks for imfo agian
alro

[alro]

Re: bfi620 flashing 1&3

jim
thanks for info i will get the bugger working now
cheers alro

[alro]

Re: bfi620 flashing 1&3

Hi gents
back to the problem of 1&3 flashing tried a new pcb fitted it drained filled washed stopped the prog to restart on prewash for customer to use back to square 1&3 flashing drains fills then drains leaving the 1&3 flashing looked for earth fault on heater cycle pump all ok but there is a pressure sensor on the wash pump when empty switch made when full switch made what does this do then and could it be the problem toresolve my no wash action
cheers a fed-up alro on this job

[alro]

Re: Bosch dishwasher SGS5302GB/07

rick
sent hope it helps
alro

[alro]

Re: Bosch dishwasher SGS5302GB/07

need email address
alro

[alro]

Re: Bosch module Pt. No. 482935/489607

marty
send me your email address
alro

[alro]

Re: Bosch module Pt. No. 482935/489607

marty
which appliance is it off
alro

[alro]

Re: F+P DD603 SHOWING F1 OR F2

thanks bigs
you seem to have hit the nail on its head as the bottom draw does not seal the water in, thus the link arm may be broken never taken one to bits (how do they come apart) do you have the part No for the link arm.
on pulling the bottom draw out the hoses flob about at rear your help on this is good news to me or does anybody have info to show me the way though this job
cheers alro

[alro]

Re: Electrolux wm1000a programme wont stop turnig

hi gents
this would have given me motor action if it was taco .
have a constant live feed to timer motor
cheers alro any ideas

[alro]

Re: BOSCHSGI45E16GB/23 FILLS THEN EMPTIES A LITTLE

whats an impelor jug do you mean flow meter
motor turns freely ill check the patr number
cheers alro

[alro]

Re: Zanussi w/d WJD1457 dryer goes to stop after 20 mins

Hi gents
guess nobody has had this fault, if so i still require any imfo please
cheers alro

[alro]

Re: Whirlpool f/freezer ART514-1H Stat housing removal

cheers gents
the light switch is the one i used to do job and did not brake anything
alro

[alro]

Re: Whirlpool f/freezer ART514-1H Stat housing removal

Hi gents
Modle is ART514-1h serive number 856451415005
still need HELP
alro

[alro]

Re: Whirlpool f/freezer ART514-1H Stat housing removal

thanks for imfo but you may be looking at wrong one

This plastic lamp cover is the whole housing which does not allow me to gain access to the stat plus the control knob is plastic and has lugs on which i broke taking it off and the stat fits into a conector block still require HELP. DOES ANYBODY KNOW
cheers alro

[alro]

Re: old creda 37753e

chris
thanks for reply but can not find anything in my box would be grateful if you could send again
cheers alan

[Author]

Posts