[alro]

Re: Whirlpool AWOD4507 door seal

any help please
alro

[alro]

Re: TECNIC TKC8122 PCB

any help please
alro

[alro]

Re: Tecnic oven TKC8122 PCB

Still looking for part looks like the belling 633r pcb part number stv08604969 does anyone know PLEASE
Cheers Alro

[alro]

Re: Whirpool DWFA10 flashes 7 times

mike
have tried search for reed switch no joy do you have a part number or where to go for one cheers alro

[alro]

Re: teka dishwasher undw655f1 poor wash

Hi gents
any help will do
cheers alro

[alro]

Re: bosch wae24260gb01 wont stop

Still stuck on this one any help please
cheers alro

[alro]

Re: Hoover Optima OPH714D fault codes f03 and f16

had this fault fo3 heater worked ok but a small insulation down on heater changed it machine worked fine
cheers alro

[alro]

Re: zanussi ZWF1650 stops on rinse

HI seamy
no blockage in pump no rinse hold on this just stop machine could it be p/switch as machine will carry on when it feels like
alro

[alro]

Re: Hotpoint WM74 E15 but no blockage

Would the heater cause the machine not to fill hot or to not spin
cheers alro

[alro]

Re: Hoover PFA167-80 wont complete spin

Thanks Martin
when the programme is selected it washes and does the rinses 60 30 15 then as it distributes picks up to spin drops down back to distribute 15 and door lock neon goes out then back on to 15 & door lock starts to ditribute again so machine does the programme selected just will not do the spin and customer has to turn off or ir does for hours
cheers alro weres the core board top or bottom one

[alro]

Re: hoover oph714 heater

Helo 75
thanks for reply if i go to search put in hoover oph714 in tec enq eo3 fault there is one that shows me that it is a oph7174d with picture showing heater with thermistor in, that the pt number i am looking for even tho the machine oph714d is the one i require the element for,
cheers alro

[alro]

Re: HT WMA62 door lock will not lock

thanks for reply i assumeb it could be but the chlid lock is not on can select any prog but the key hole flashes when start button pressed and bleebs 5 times no fault code apears or is this 5 bleeps a code
any more checks i can do would help me
cheers alro

[alro]

Re: candy/hoover CFMF235A F/Freezer

thanks bob
email address pm to you
cheers alro

[alro]

Re: cda 447 d/w bottom spay arm no go

thanks chris
going back tomorrow
cheers alan

[alro]

Re: hoover HNWL 7146-80

hi bazza500
serial number 3100136208069291 of plate
cheers alro

[Author]

Posts