bazza500

Forum Replies Created

Viewing 15 posts - 31 through 45 (of 1,916 total)
1 2 3 4 … 126 127 128
  • Author
    Posts
  • April 29, 2017 at 10:19 pm in reply to: heater element 1888130100 poss req #447261
    bazza500
    Participant

    Re: heater element 1888130100 poss req

    The relay on the board is a common failure on this model

    April 12, 2017 at 10:46 pm in reply to: Maytag/Whirlpool 3LMVWC400YM3 #446786
    bazza500
    Participant

    Re: Maytag/Whirlpool 3LMVWC400YM3

    you’re right it is a yw3at the end

    April 5, 2017 at 6:26 pm in reply to: Capel DI626 Dishwasher not heating. #446637
    bazza500
    Participant

    Re: Capel DI626 Dishwasher not heating.

    This seems to have a water pressure switch assy which are prone to failure on the CDA badged ones. This will stop the heat but it will complete the cycle.

    Part is 674010020008 if it’s required

    April 3, 2017 at 8:02 pm in reply to: AEG dishwasher 5 flashes #446608
    bazza500
    Participant

    Re: AEG dishwasher 5 flashes

    Motor triac short cct

    March 24, 2017 at 7:56 pm in reply to: Beko lense behind pcb #446425
    bazza500
    Participant

    Re: Beko lense behind pcb

    called the light guide

    March 5, 2017 at 2:03 pm in reply to: Zanussi Tumble Dryer ZDC8202p #445814
    bazza500
    Participant

    Re: Zanussi Tumble Dryer ZDC8202p

    You would need a meter with a capacitance test facility unfortunately.

    March 5, 2017 at 1:52 pm in reply to: Zanussi Tumble Dryer ZDC8202p #445812
    bazza500
    Participant

    Re: Zanussi Tumble Dryer ZDC8202p

    If it were me, I would be checking the capacitors and if they are reading correctly then I’d be replacing the motor.

    March 5, 2017 at 1:35 pm in reply to: Zanussi Tumble Dryer ZDC8202p #445810
    bazza500
    Participant

    Re: Zanussi Tumble Dryer ZDC8202p

    Probably the motor capacitor is faulty.

    Does it struggle to turn when there is a bigger load in it? Try it empty and see if it seems to work fine.

    If the above is the case then it will be the capacitor.

    March 5, 2017 at 1:26 pm in reply to: UK Service Maintenance Group Ltd #445775
    bazza500
    Participant

    Re: UK Service Maintenance Group Ltd

    Check it out here Dave.

    http://www.whitegoodstradeassociation.org/

    March 2, 2017 at 10:51 pm in reply to: zcv662mno #445726
    bazza500
    Participant

    Re: zcv662mno

    some cooling fans will switch through the grill/top oven switch which is in parallel with the stats so that the fan runs all the time the grill is used to prevent the controls getting hot.

    February 17, 2017 at 5:57 pm in reply to: D&G PORTAL SYSTEM #445423
    bazza500
    Participant

    Re: D&G PORTAL SYSTEM

    They didn’t mention anything about prebooking calls to me, just that the jobs would be sent through the portal and we would have to contact the customer.

    February 16, 2017 at 6:51 pm in reply to: DRCS 68 B Fan #445395
    bazza500
    Participant

    Re: DRCS 68 B Fan

    no. it’s a complete motor c/w fans

    February 15, 2017 at 7:11 pm in reply to: HOW FAR WOULD YOU WALK TO A JOB #445356
    bazza500
    Participant

    Re: HOW FAR WOULD YOU WALK TO A JOB

    I think about 8 yards is the furthest I have to walk to a job 🙂

    But then again I can travel 10 miles between jobs and not see another vehicle.

    February 15, 2017 at 7:03 pm in reply to: Hotpoint 2 year old TCUD97B6HM(UK) #445373
    bazza500
    Participant

    Re: Hotpoint 2 year old TCUD97B6HM(UK)

    Yep, replacing the belt on one tomorrow for exactly the same thing.

    February 2, 2017 at 10:54 pm in reply to: Currys essentials dishwasher Cdw60w13 #444983
    bazza500
    Participant

    Re: Currys essentials dishwasher Cdw60w13

    There’s an exploded diagram on mediator on Connect

  • Author
    Posts
Viewing 15 posts - 31 through 45 (of 1,916 total)
1 2 3 4 … 126 127 128