Forum Replies Created
-
Posts
-
Re: Haier HW-C1470TVEME-U
The bearings are a 6205 (OEM part no. 0020102392) and a 6206 (OEM part no. 0020102393) and the part number for the seal is 0020300440
The bearings sizes are equivalent to the older hotpoint machines me thinks.
Re: markup on new machines
That basically is the same scenario as myself.
What your colleague is failing to grasp is, most machines are sold before they are due to be paid for, so actually there is no outlay.
Re: Beko WMA765S
Hi Rob,
Had something similar last week, and I think it was the same model. Removal company broke the knob off. I replaced the selector switch but it wouldn’t programme and just kept doing wierd things. I replaced the board but it still wasn’t right. Then put it through a test. It did that okay and then worked normally after that. Haven’t heard anything since so can just assume it is still working.Re: Indesit single oven intermittent fault
If the RCD is tripping then there is an earth fault in the oven. 99{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} of the time this is caused by the element but without putting an insulation tester on the appliance you could not be 100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} sure.
Re: Xmas 2010
Okay Tracey, If you can let me know when you have confirmed the meal and I will book a room. The Park are currently advertising only 4 doubles left for that date.
Re: DSG/RepairCare Rate Cuts
Welcome to the bright side Ade!!
If the numbers don’t add up to a reasonable profit then hard decisions have to be made. There is no point knocking your pan in for loads of cashflow and no profit.
Now if only more people would do the number crunching and be honest with themselves on whether they are making any money out of these contracts. The WP’s would get the message sooner or later unless they stick their heads in the sand like Bernard at the meeting.Re: A lesson learnt!
He made one valid point which I think other people will pick up on.
DrDill wrote:
i had a lot of concerns, one of which was companies or individuals are allowed to be members without any form of appraisal, was it the intention of all members being eventually OFT and ISO compatible?.I know there is nothing we can do about people joining, but when do members have to start leaving the questionnaires behind? Is this to be done before the OFT approval of the COP? Pre- appraisal of companies before joining just isn’t possible in my opinion but we should be seen to be monitoring members somehow. This I think would give some credibility to the WTA by members and prospective members.
