Forum Replies Created
-
AuthorPosts
-
bazza500
ParticipantRe: VTD00P
You need to replace the drum with a modified one.
bazza500
ParticipantRe: Hoover (Gias) Engineers No Work
Wouldn’t start my van for £30 per call…
bazza500
ParticipantRe: Whirlpool Thermostat/Switch
This then?
bazza500
ParticipantRe: Whirlpool Thermostat/Switch
I have the thermostat part without the selector switch if it’s that part you need?
bazza500
ParticipantRe: whirlpool fault
Yes that ball is supposed to be there.
bazza500
ParticipantRe: no work
not if you dial 01217662200
bazza500
ParticipantRe: connections Log In
It’s always been 3 but we send it at 2.30ish to be on the safe side.
bazza500
ParticipantRe: nightmare
I’m trying to remember what I did. It was ages ago.
It may have been the screw which holds the little lever thing in the centre of the hinge had came out. Try that.
I know it was something simple once I traced it.
bazza500
ParticipantRe: nightmare
I had this a while back and I’m sure it was just the screws holding the decor door on that were loose that prevented the door shutting the last inch. Thats if my memory serves me right.
July 14, 2009 at 8:59 pm in reply to: Trying to identify Brand and Model of my washing machine #292142bazza500
ParticipantRe: Trying to identify Brand and Model of my washing machine
The machine is 4 years old.
July 14, 2009 at 8:56 pm in reply to: Trying to identify Brand and Model of my washing machine #292141bazza500
ParticipantRe: Trying to identify Brand and Model of my washing machine
I think the only wierd thing about this machine was you had to have the half load button in to use the dryer. ( I think)
July 14, 2009 at 8:46 pm in reply to: Trying to identify Brand and Model of my washing machine #292136bazza500
ParticipantRe: Trying to identify Brand and Model of my washing machine
It’s Diplomat badged but it’s made by Servis. Any other numbers? Maybe a serial number?
July 14, 2009 at 8:38 pm in reply to: Trying to identify Brand and Model of my washing machine #292133bazza500
ParticipantRe: Trying to identify Brand and Model of my washing machine
You’ve got to be quick Jim :waving:
July 14, 2009 at 8:35 pm in reply to: Trying to identify Brand and Model of my washing machine #292132bazza500
ParticipantRe: Trying to identify Brand and Model of my washing machine
It may be screwed from the front or the screws could be going down into the plinth inside the cupboards. I doubt it will be attached to the floor.
July 14, 2009 at 8:30 pm in reply to: Trying to identify Brand and Model of my washing machine #292129bazza500
ParticipantRe: Trying to identify Brand and Model of my washing machine
Hey! look at that! I’m answering your questions before you ask them. 😀
-
AuthorPosts
