Forum Replies Created
-
Posts
-
Re: GBDAR/MFI
You don`t have to pay the VAT if you are “Cash Accounting” like I do but if you are “Invoice Accounting” then I`m afraid, as Ken says, you have to pay it and then claim it back later.
Re: Servis UK (Antonio Merloni) Bust!?
Well luckily due to a cock-up by GBDAR who had me on holiday for 2 and a half months 😯 I will only be writing off £32.
My condolences go out to the people who are getting stung for what I can only imagine will be a lot, lot more. Let`s hope you can survive this.
Re: Servis UK (Antonio Merloni) Bust!?
Just tried to log on to the Servis website using username and password given by GBDAR and it gets rejected however I can still get in with JTM’s logon.
Re: ISIS 1205
Been out to 2 so far and both have been not spinning due to out of balance loads. Seems to be quite sensitive to this.
I think they are chinese piles of………. but I could be wrong.
Re: Bosch WFG 2420 Washer Programmer / Control Unit Required
Just to back up what Jim is advising. The rrp of the power module is £180.95.
Re: ISE 2 Problems
I had the door lock fault on the very first ISE2 I installed. It seemed that as the door went to unlock the water valve opened momentarily and the door locked again. It kept repeating this until switched off.
Re: Servis UK (Antonio Merloni) Bust!?
As I said in a previous post, I hadn`t had a job from GBDAR for 2 months so they are owe me nothing at the moment.
Is there anyone out there who has not had their september payment from GBDAR? and if you did get it, was it late?
Re: Servis UK (Antonio Merloni) Bust!?
I hadn`t had a job from GBDAR for nearly 2 months and now 2 in 3 minutes. I`ll have to move my printer to above the bin.
Re: closing down
well I`m off back to Tenerife tomorrow.
(well it is nearly 10 weeks since Mexico 8) )
