[bigchrisoioi]

Re: Beko drc568 cond drier

press and hold the start button to reset it…hold it for about 3 seconds and the lights will flash to end….also, make sure the condensor clips are locked, there is a red on top right corner that has a microswitch behind it….caught me first time i saw one, i thought the pcb was duff lol

[bigchrisoioi]

Re: JLTDC05 condenser dryer wont start

it is deffo the diffusor…..15 min job

[bigchrisoioi]

Re: Zanussi ZDT6252 not filling.

check for insulation mate….or unplug the heater…..if this is low , it will pump and pump!

[bigchrisoioi]

Re: AEG 88730 washer. C6 fault

had this recently….check the heater insulation….may have to get it wet first…but mine was low insualtion heater after running it for 10 mins…!

[bigchrisoioi]

Re: zanussi zwd1471w machine wont start

disconnect the dryer element , if it starts u have got it……any insulation below 40 megs will cause a diagnostic code of ED4 or E36

[bigchrisoioi]

Re: ZDF221 d/w HEAT PRTOBLEM

broken cable in bottom of door as it enters tub?

[bigchrisoioi]

Re: New Electrolux Washer (Chinese)

they are not that bad too be honest !…repaired 4 now, 3 pcb’s (10 mins in and out!), and a drain hone 3mins!!….simple machine

[bigchrisoioi]

Re: Zanussi WJD1667W drier issues.

if there is no error code, i would say pcb!

[bigchrisoioi]

Re: bosch wae24162gb spin/wash light flashing

many thanks for your help m8

[bigchrisoioi]

Re: bosch wae24162gb spin/wash light flashing

would u have a list of the fault codes…….all the spin lights were flashing?

[bigchrisoioi]

Re: AWO/D4504 fault codes

i have but a post for these codes as well…can you send my some info please please please???? 😀

[bigchrisoioi]

Re: Zanussi ZWD 1472 S unusual washer dryer fault

e10 > open circuit coil on valve

e20 > blocked condensor

[bigchrisoioi]

Re: famous customers?

sophie ellis bextors refreshment machine last week

[bigchrisoioi]

Re: Zanussi Jetsystem ZWF 14581 W

anti flood in base????…….’efo’ fault code in diagnostics?

[bigchrisoioi]

there is more to come..i have seen the new machines with filters accessed through the drum paddle…..looks ace

[Author]

Posts