Forum Replies Created
-
Posts
-
Re: big shake up at baumatic
although i am sorry people are losing their jobs, i have no feelings with in mu opinion overpriced badged up rubbish they call premuim appliances….
Re: whirlpool dishwasher gdp4801 851150415831
thanks, i will be going back with flowmeter and motor,,…..rather not get involved but been dumped on me ….thanks again
Re: Zan FLE 1016W. Lights 1, 4 & 8
just to show how it looks, this is it on machine—
8
4
2
18
4
2
1Re: Zan FLE 1016W. Lights 1, 4 & 8
deffo 91…its the blue cable between the power and display PCB…either replace it ot tweak the pins carefully to make tighter fit on the pcb’s….i always replace the cable and the jobs is good….ok, the lights are easy….the 8 lights are in 2 banks of 4…using binary logic, working from bottom the lights are as following 1,2,4,8 – 1,2,4,8….so add the numbers up on each bank of 4!!!…easy i hope or i have confused the hell out of u …configeration of 15 codes using this display can be fun lol
Re: zanussi zwf12070w1
easier than that….start the program and as it starts to run hold the start and the button to the left of it together for a few seconds and the display will show the code…let go of buttons and it will disapear just after….
Re: Beko DRCS68S S/N 09-206777-12 condenser dryer no heat
easy job though ….and the heater is cheap as chips
Re: drum lifter removal
ok…..small terminal driver through the 2nd or 3rd holes from the rear of the paddle to vend the tag down…the paddle slides towards the door…the screw (if fitted) will drop in the sump , i have never bothered to find it and it has never caused a recall.To put back on force into slots in tub and then push back towards back of drum….hope that helps
Re: ZKI245 Dryer problems
check the error code in diagnostics…..E10 willbe faulty 3 way valve, E73 will be broken NTC cables….E22 will be blocked condensor…these are the most likely ones
Re: AEG Favorit 35085 VI (911939603)
should be able to set program then……if not, must be a PCB fault
Re: Beko fridge freeze recall
serviceforce agents doing beko re-ops now as well………. while i am at it, i have a bucket load of defrost timers if anyone wants to invest 😉
Re: AEG & Zanussi/Electrolux Frost Free – Fridge not cooling
normally fan problems, the bearings get tight and you lose the fan…make sure that the evaporator is clear and not iced up….have had many defrost heater faults
