Forum Replies Created
-
Posts
-
Re: Replacement model for APM6842
Just to say I bought one of these
and it fitted straight in no problem
Re: Replacement model for APM6842
Dave, it’s something I should check right enough. Looking at the picture there is does look a tight fit and maybe there is no vent hole at back. Will get it checked out.
ThanksRe: Replacement model for APM6842
Actually I have been having a look online and yes there are a few that should do. Just need to check the cabinet height as that could be critical.
And they all seem to come with sliding rails.
Thanks again for helping out.Re: Replacement model for APM6842
Thanks Don for your reply. It would help me a lot if you or somebody else could give me a make and model number of a currently available suitable appliance in a reasonable price range.
Re: Schreber Freezer APP6403 stopped freezing
Well its just the relay part which is soldered to the pcb that I have. Cost is £6 posted. Its very easy to solder in place. Getting the old one of is more tricky but a simple job to anyone who does solder work.
I can take paypal
Re: Schreber Freezer APP6403 stopped freezing
Hi,
After redaing some other posts I managed to fix the pcb in my Freezer. It was doing the same thing, Temperature dropping, red light on, bleeping. Press fast freeze and it would refreeze but back to same problem after a day or so.
In my case it turned out to be a faulty relay on the PCB. I ordered a replacement from RS. However the minimum order was 5 so i have 4 left.
If you are interested in getting one from me or need help fitting it give me a shout.
Re: APP 6302 problems
and you think I need a new top hinge rather than replacing the seal to keep the door shut.
Re: APP 6302 problems
Ok thanks for reply.
How do i check for clogged drain hole ?
and there seems to be a hell of a lot of water, where does it come from / go to ?
Re: Hotpoint CTD00 Condenser Tumble, tripping my power point
Thanks for the advice. I’ll have a look at the elements and see what they are like.
Re: Proline DW 6006 Dishwasher sticks toward end of cycle
There is no blockage between machine and drain… checked it.
Water appear to run out of the machine ok… so ther is no internal blockage.
I’ve lifted the machine up and on its back, taken the bottom plate off and look around the workings. Everything appears newish and no obious problems. Looking at it though it looks simple enough to fit a new pump.
Where would be the best place to get one from… or shoul I put that question in another part of the forum ?
My postcode is EH51 9JB
