BobHope

Forum Replies Created

Viewing 15 posts - 361 through 375 (of 1,373 total)
  • Author
    Posts
  • in reply to: candy cpca 300k #363145
    BobHope
    Participant

    Re: candy cpca 300k

    you clearly have the incorrect start device for your compressor, please post up the numbers off the compressor, and also hope you have not burnt out the start winding of the compressor by applying the power to the incorrect terminals.

    Bob.

    in reply to: Brandt Apollo CO38AWMU back inside fridge panel expanded #362716
    BobHope
    Participant

    Re: Brandt Apollo CO38AWMU back inside fridge panel expanded

    the most likely suspect is a refrigerant leak from the fridge evaporator pipe located behind the back panel.

    Bob.

    in reply to: AEG Washer L76650 Will Only Empty #362881
    BobHope
    Participant

    Re: AEG Washer L76650 Will Only Empty

    the earth leakage plays havoc with the electronics, may show random codes, its best to test all external componats first.

    Bob.

    in reply to: AEG Washer L76650 Will Only Empty #362879
    BobHope
    Participant

    Re: AEG Washer L76650 Will Only Empty

    the appliance has an earth leakage somewere, check the heaters and motor with an insulation tester.

    Bob.

    in reply to: Flashing Lights on Drying Cycle #362873
    BobHope
    Participant

    Re: Flashing Lights on Drying Cycle

    that fault is an F13 fault code, if you use your dryer a lot its possible the flushing filter or condenser are blocked, not realy a diy job but if you do have a go please pull the mains plug out first.

    Bob.

    in reply to: Flashing Lights on Drying Cycle #362871
    BobHope
    Participant

    Re: Flashing Lights on Drying Cycle

    just ignore the option lights that flash, look at the vertical progress indicators, thats the ones with the door lock at the bottom, when the fault appeares just mark down on a piece of paper which light is lit and which are not start from the bottom,then just post back the results.

    Bob.

    in reply to: Brandt Apollo CO38AWMU back inside fridge panel expanded #362713
    BobHope
    Participant

    Re: Brandt Apollo CO38AWMU back inside fridge panel expanded

    as a precaution please turn off your appliance and leave the doors open untill you seek an engineer to have a look at your appliance.

    Bob.

    in reply to: LG Washing Machine always heating water #362685
    BobHope
    Participant

    Re: LG Washing Machine always heating water

    have you checked your plumbing connections as it is possible you have the hot water connected to the cold inlet valve.

    Bob.

    in reply to: w/pool awod4406 belt #362602
    BobHope
    Participant

    Re: w/pool awod4406 belt

    part number for the belt is 481235818214

    Bob

    in reply to: SBS Plumbing kit #362589
    BobHope
    Participant

    Re: SBS Plumbing kit

    WPL481281718405, LGE4932JA3018A,from connect distribution.

    Bob.

    in reply to: Mains terminal block burnt #362587
    BobHope
    Participant

    Re: Mains terminal block burnt

    in general they burn up because of poor installation, wire bridging links not tightened, poor cable fitting and not fitting earth sleeving on the bare earth then tightening it down on to one of the phase wires.

    Bob.

    in reply to: Flavel FLS61FX Oven #362577
    BobHope
    Participant

    Re: Flavel FLS61FX Oven

    if its product code 7729486366 its part number 2631000015.

    Bob.

    in reply to: WMF740 #362583
    BobHope
    Participant

    Re: WMF740

    no valve listed just the complete dispenser, the extention pieces have now been removed and the cover is longer with a new valve mounting, it comes as a kit.
    your part number is correct.

    Bob.

    in reply to: HOTPOINT BWM 129 #362443
    BobHope
    Participant

    Re: HOTPOINT BWM 129

    have a look here,
    http://www.ukwhitegoods.co.uk/help/fix- … arks-.html

    Bob.

    in reply to: Is a licence required for refrigeration system work? #362232
    BobHope
    Participant

    Re: Is a licence required for refrigeration system work?

    the main problem here is not the 3kg limit but safe handling and disposale of any refigerant that you have removed from a system, you need to record R134a disposale and if it exceeds the 3kg you are in trouble.

    Bob.

Viewing 15 posts - 361 through 375 (of 1,373 total)